STORZ & BICKEL PLENTY (01) PDF Document

Step 1. Open the Filling Chamber.

Step 2. Grind your materials.

Step 3. Fill the Filling Chamber. Always fill the Filling Chamber completely up to the upper edge.

There are two correct ways to fill the chamber:

Completely filled: For a full session, fill the chamber completely with your ground materials. This will produce vapor.

Partially filled: If you only wish to partially fill the chamber, you must place the Liquid Pad on top of your materials. This will also produce vapor.

An incorrectly filled chamber, where it is only partially filled without the Liquid Pad, will produce hot air instead of vapor.

Step 1. Switch on the device using the orange power switch.

Step 2. Press the auto off release handle.

Step 3. Choose your desired temperature using the temperature scale dial.

The vaporization temperature scale has 7 levels:

The PLENTY Vaporization Unit consists of the following parts:

Mouthpiece

Upper Tubing Section (long)

Cooling Coil

Lower Tubing Section (short)

Filling Chamber Cap

Upper Screen

Lower Screen

Filling Chamber Cylinder

Filling Chamber Housing

Step 1. Pull the Mouthpiece away from the Cooling Coil.

Step 2. Pull the Cooling Coil out of the Filling Chamber Cap.

Step 3. Push out the Upper Screen with the help of the Cleaning Brush.

Step 4. To disassemble the Filling Chamber, push out the Filling Chamber Cylinder.

Step 5. Push out the Lower Screen.

Perform a manual cleaning of the disassembled components, such as the Filling Chamber Cylinder and Housing, using alcohol (min. 90%) or dishwashing soap.