SPIDER FARMER SF-SMARTJAR-01 (01) PDF Document

Step 1. Before Operating: Place the vacuum lid securely onto the jar and ensure it is properly closed.

Step 2. Wake Up the Screen: Press and hold any button for 3 seconds to wake up the screen. The screen will remain active for 9 seconds, during which you can perform operations.

Step 3. Lock: Press the “Lock Key” button in the center of the host to start the vacuum process.

Step 4. Unlock: Before opening the lid, press and hold the “Unlock Key” button on the left for 3 seconds to release the internal pressure.

Step 5. Time Reset: Press and hold the “Time Reset” button on the right for 3 seconds to reset the stored time.

Step 6. Automatic Air Pressure Detection: While in standby mode, the vacuum lid will continuously monitor the air pressure inside the jar. If a pressure leak causes the negative pressure to drop to a certain level, the system will automatically re-initiate vacuuming.

Step 7. Temperature and Humidity Display: Real-time display of temperature and humidity inside the jar. Press the “Time Reset” button once to switch between Celsius and Fahrenheit.

Step 8. Power Display: The battery icon will flash while charging and will disappear once fully charged.

If the “Unlock Key” button is flashing, it indicates a leak. The system will automatically shut down.

1. This product is intended for home and indoor use only.

2. Please use with care. The plastic bag is for wrapping the vacuum container only. To prevent the risk of suffocation, keep the plastic bag away from children. Do not use this bag in cribs, beds, or playpens. This bag is not a toy.

3. Do not store liquids in the jar, and never place the jar upside down if there is powder inside.

4. Do not heat any part of this product directly over an open flame or on an induction cooker, as it may cause thermal deformation or damage.

5. The lid contains a motherboard and batteries. Do not place it in a microwave or expose it to freezing temperatures below 32°F.

6. When cleaning, do not immerse the lid in liquid. Do not clean it with water above 140°F.

7. Do not use steel wool, abrasive cleaners, or corrosive liquids (such as gasoline or acetone) to clean the product.

8. Do not place the lid in a dishwasher. Only the stainless steel jar is dishwasher safe.

Note: Parts that come into contact with food comply with food-grade certification standards.

1. Clean the product promptly after each use. Rinse food-contact surfaces with clean water and wipe dry.

2. Wipe the exterior of the main unit with a damp cloth. Do not rinse or immerse in liquid.

3. Store the product in a dry place. Avoid exposure to direct sunlight or UV radiation.

4. Ensure the product is clean and dry before storage.