SPIDER FARMER GLOW30 (01) PDF MANUAL

1. Use the cable to connect 2 light bars in series.

2. Unbox the black hanging kits and attach them to the 4 holes. Hang the light above the plants at an appropriate height.

3. Ensure the assembly is complete, then plug the power cord into the socket.

Tip: When hanging vertically, insert the fixed rod into the grooves to secure the light bar’s illumination angle.

1. Confirm the installation positions for the four light bars. Cut the appropriate lengths of adhesive-backed Velcro for each one, remove the paper backing, and stick them inside the tent.

2. Attach the four fixing clips by snapping the back of each light bar onto the clips. Use the Velcro side to securely fasten the light bars inside the tent.

3. Ensure the assembly is complete, then plug the power cord into the socket. Additional programming can be set up using a digital timer.

Tips:

• The spacer that holds the carabiner can be rotated to adjust the direction of the light bar.

• Adhesive-backed nylon is compatible with smooth surfaces such as the inside of the grow tent, metal, wood, plastic, or glass.

• Avoid usage with rough surfaces like brick walls, plastered walls, or wet and uneven areas.

GlowR40:

1. Up to 16 single bars can be connected in series under 110V.

2. Up to 32 single bars can be connected in series under 220V.

GlowR80:

1. Up to 8 single bars can be connected in series under 110V.

2. Up to 16 single bars can be connected in series under 220V.

Glow30 / Glow80:

Refer to the Max Daisy Chain Number in the specifications table for your specific model.

1. This light is Class I protection equipment and must be properly grounded.

2. The power supply should only be connected by qualified professionals.

3. Before use, ensure the voltage matches the specified value in the operation manual.

4. For daisy chain operations, ensure the total power does not exceed your timer’s rated capacity.

5. Do not touch the product while it is in operation.

6. Avoid looking directly at the lights without wearing protective glasses.

7. To disconnect the power cord, pull on the plug only; do not apply excessive force to the cable itself.

8. Exercise caution and adhere to electrical safety guidelines during installation. Avoid contact with exposed wires to prevent the risk of fatal electric shock.

9. Unplug the power cable during storms or rainy weather to reduce the risk of lightning strikes.

10. Always unplug the light before cleaning or performing repairs.

11. Do not disassemble, repair, or modify the light without the manufacturer’s authorization unless performed by qualified professionals.

12. The maximum operating temperature is 40°C. Do not operate the light above this temperature.

13. Do not connect the light to unauthorized dimming devices.

Cooling: Natural convection dissipates heat from the heat sink. To ensure proper cooling, maintain at least a one-inch gap between the fixture and the roof of your grow area. Failure to do so may shorten the fixture’s lifespan.

Cleaning: Routinely check and remove dust, debris, and mineral build-up from the heat sink and LED array to maximize lifespan and performance. Always clean the fixture while it is unplugged. Use low-pressure compressed air for safe and effective cleaning.

Handling: Never use a cloth to clean the diode array, as this may scratch or damage the silicon seal or dislodge the diodes. Avoid touching the diodes with your hands, even when the fixture is powered off, to minimize degradation.