Free English SENNHEISER ME 5005 E (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD SENNHEISER ME 5005 E (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
What is included with the SENNHEISER ME 5005 E?
The SENNHEISER ME 5005 E package includes the following items:
• ME 5005 e microphone head
• Pop protection
• Pouch
• Instruction manual
How do I mount the SENNHEISER ME 5005 E capsule head?
To mount the SENNHEISER ME 5005 E capsule head onto a compatible Sennheiser handheld transmitter, follow these steps:
Step 1. Unscrew the sound inlet basket from the handheld transmitter.
Step 2. Screw the ME 5005 e microphone head onto the handheld transmitter.
How do I clean the SENNHEISER ME 5005 E?
To clean your SENNHEISER ME 5005 E, you can clean the sound inlet basket. Follow these steps:
1. Unscrew the sound inlet basket from the microphone head.
2. Remove the foam insert from the sound inlet basket.
3. Clean the sound inlet basket with a damp cloth.
4. Clean the foam insert with a mild detergent or replace it, if necessary.
5. After cleaning, let the foam insert dry completely.
6. Insert the dry foam insert into the sound inlet basket.
7. Screw the sound inlet basket back onto the microphone head.
Only use a soft, damp cloth to clean the product from time to time. Do not use any solvents or cleansing agents.
What should I do if there is no sound from my SENNHEISER ME 5005 E?
If there is no sound from your SENNHEISER ME 5005 E, please check the following possible causes and their remedies:
| Possible Cause | Remedy |
|---|---|
| Transmitter is switched off | Switch the transmitter on. |
| Receiver is switched off | Switch the receiver on. |
| Transmitter and receiver are not on the same frequency channel | Set transmitter and receiver to the same frequency channel. |
| No connection from the receiver to the mixing console | Check the cable connection. |
| Mute function of the transmitter is activated | Deactivate the mute function. |
What should I do if the sound from my SENNHEISER ME 5005 E is distorted?
If the sound from your SENNHEISER ME 5005 E is distorted, please check the following:
| Possible Cause | Remedy |
|---|---|
| AF level is set too high | Reduce the AF level. |
What are the technical specifications for the SENNHEISER ME 5005 E?
The technical specifications for the SENNHEISER ME 5005 E are as follows:
| Transducer principle | pre-polarised condenser microphone |
| Pick-up pattern | super-cardioid |
| Frequency response | 40 to 20,000 Hz |
| Sensitivity | 1 mV/Pa |
| Sound pressure level (at 1 kHz) | 140 dB (SPL) |
| Powering | approx. 7.5 V (from handheld transmitter) |
| Current consumption | approx. 300 μA |
| Dimensions | ø 47.5 mm, L = 72.5 mm |
| Weight | approx. 110 g |
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
CLICK HERE TO DOWNLOAD SENNHEISER ME 5005 E (01) PDF DOCUMENT