SENCOR SHB 4359WH (01) PDF Document

The SENCOR SHB 4359WH stick blender and its accessories include the following parts:

A1 Normal speed switch

A2 High speed switch (turbo)

A3 Motor unit

A4 Removable blender stick attachment

A5 Blade assembly (Contains 4 stainless steel blades)

A6 Beaker, volume 700 ml

A7 Anti-slip base pad / lid

B1 Help arrow

B2 „Unlocked” symbol

B3 „Locked” symbol

The SENCOR SHB 4359WH stick blender is designed for household use and is intended for blending, chopping, and whipping food. It is suitable for blending soft ingredients and liquids as well as processing hard ingredients such as coffee beans, cocoa beans, ice cubes, nutmeg, etc. It is specifically useful for preparing baby food, various types of shakes, sauces, and spreads.

The appliance is intended for domestic use and similar locations such as:

– kitchens in stores; offices and other workplaces;

– in agriculture;

– for guests of hotels, motels and other similar locations;

– in bed and breakfast establishments.

This appliance is not intended to be operated using an external timer switch or a remote control system.

Before using the SENCOR SHB 4359WH for the first time, thoroughly wash the accessories that come into contact with food (blender stick attachment A4, blending beaker A6, and base pad A7). Use warm water with a neutral kitchen detergent. After washing, rinse them with clean water and allow them to dry naturally or wipe them thoroughly dry with a fine wiping cloth.

Attention: When cleaning the blade assembly A5, be very careful not to injure yourself on its sharp edges. Do not submerge the top end of the blender attachment A4 that connects to the motor unit A3.

Assembly:

1. Before attaching or removing the blender stick attachment A4, ensure the motor unit A3 is turned off, disconnected from the power socket, and the rotating parts have completely stopped. The connection point must be dry.

2. Slide the attachment A4 onto the motor unit A3 from underneath so that the arrow (B1) on the rear of the motor unit points at the unlocked padlock symbol (B2) on the attachment.

3. Turn the motor unit so that the arrow moves to the locked padlock symbol (B3). A click will indicate the parts are connected.

Blending:

1. Use the beaker A6 or another suitable container for blending. The anti-slip base pad A7 can also be used as a lid for the beaker for short-term food storage.

2. Do not overfill the beaker A6 past the maximum level mark to prevent splattering.

3. Connect the motor unit A3 to a power socket.

4. Put the blender attachment into the bottom of the beaker. Use the normal speed switch (A1) or high speed switch (A2) to start the appliance. Move the blender slowly up and down to blend the ingredients to the desired consistency.

5. The appliance will run as long as the switch is held down. Releasing the switch will turn off the appliance.

Disassembly:

1. To release the attachment, firmly grasp both the motor unit and the attachment and turn the motor unit so the arrow points at the open padlock symbol.

2. Pull both parts away from each other.

Operating Time:

The maximum continuous operating time of the appliance is 1 minute. After 1 minute, allow it to cool down for 3 to 5 minutes. When blending sticky or harder foodstuffs, interrupt operation after 30 seconds.

To get the best results with your SENCOR SHB 4359WH stick blender, follow these tips:

• It is recommended to always start blending at a lower speed.

• To prevent ingredients from splattering, insert the blender attachment A5 into the beaker with ingredients before starting it. Similarly, turn it off before pulling the attachment out of the beaker.

• Keep the blade assembly A6 submerged while the appliance is running to prevent splattering. For larger amounts, process ingredients in several smaller batches.

• When using the blender attachment, it is recommended to use short pulses. This helps prevent ingredients from being excessively pulverized and achieves optimal results.

• To make blending and chopping easier, cut hard ingredients into small pieces first.

• For better blending results, hold the stick blender slightly tilted while carefully moving it up and down in the beaker. Do not use force to push ingredients down with the blender.

• Before blending or chopping, remove hard parts like fruit stones or bones from the ingredients to prevent damage to the blade assembly.

The following table provides a quick guide for processing various ingredients. These times are a reference; the actual time depends on the size, amount, and desired consistency of the ingredients. First, cut food into approximately 2 cm cubes before blending. For vegetables like onions, cutting them into quarters is sufficient.

For cleaning and maintenance, follow these steps:

1. Before cleaning, ensure the appliance is turned off, disconnected from the power socket, and that the rotating parts have completely stopped.

2. Disassemble the appliance into its individual parts.

3. Thoroughly wash the used blender attachment and beaker in warm water with a neutral kitchen detergent. Then rinse them with clean water and allow them to dry naturally or wipe them dry with a cloth.

4. Attention: When cleaning the blade assembly A5, be very careful not to injure yourself on its sharp edges.

5. When cleaning the blender attachment A4, do not submerge the top end that connects to the motor unit A3.

6. The beaker A6 and the anti-slip base pad A7 can be washed in a dishwasher. Other parts are not intended for dishwasher use.

7. Quick Blade Cleaning: It is also possible to clean the blade assembly A5 by submerging it in warm water with kitchen detergent and running it for a short time. Afterwards, disconnect the appliance, disassemble it, and rinse the blade assembly with clean drinking water and dry it thoroughly.

8. To clean the outer surface of the motor unit A3, use a cloth lightly dipped in a weak detergent solution. After applying the detergent, wipe the surface with a cloth lightly dampened in clean water and then wipe dry. Do not use solvents or abrasive cleaning products.

Important: Never submerge the motor unit A3 or its power cord in water or any other liquid.

When you have finished using the appliance, place it and its accessories in a clean, dry place out of children’s reach. Keep the stored appliance and its accessories away from extreme temperatures, direct sunlight, and excessive humidity. Do not store it in an overly dusty environment.

Please adhere to the following general warnings:

• This appliance may not be used by children. Keep the appliance and its power cord away from children.

• Persons with reduced physical, sensory or mental capabilities may use the appliance only if supervised or instructed on its safe use and understand the potential dangers.

• Cleaning and maintenance must not be performed by unsupervised children.

• If the power cord is damaged, it must be repaired at a professional service centre. Do not use the appliance with a damaged power cord.

• Be extremely careful with the sharp cutting edges of the chopping blades, especially when removing them, emptying the container, and during cleaning.

• Surfaces that contact food must be cleaned according to the user’s manual.

• Always turn off and disconnect the appliance from the power socket when not in use, before assembly, disassembly, cleaning, moving, or if left unsupervised.

• Before changing accessories, turn off the appliance and disconnect it from the power supply.

• Children must not play with the appliance.

Please follow these electrical safety guidelines:

• Before connecting, ensure the voltage on the rating label matches your power socket voltage.

• Connect the appliance only to a properly grounded socket. Do not use an extension cord.

• Do not connect the appliance to a power socket until it is properly assembled.

• Fully unwind the power cord before use.

• Do not handle the power cord or plug with wet hands.

• Ensure the power plug contacts do not touch water. If they do, dry the plug carefully before using it again.

• Disconnect the appliance by pulling on the plug, not the power cord.

• Do not place heavy items on the power cord or let it hang over a table edge or touch hot surfaces.

• Do not wind the power cord around the appliance.

• To avoid electrical shock, do not attempt to repair the appliance yourself. All repairs must be performed at an authorised service centre.

• Never submerge the motor unit and its power cord in water or any other liquid, or wash these parts under running water.

• If the appliance falls into water, immediately disconnect it from the power socket. Do not reach for it. Have it inspected by an authorised service centre before using it again.

For safe operation of your SENCOR SHB 4359WH, please observe the following:

• Use the appliance and its accessories only as instructed in the user’s manual and only with original accessories.

• Before each use, check the selected accessory for damage. Do not use a damaged accessory.

• Place the appliance on an even, dry, and stable surface. Do not place it near stoves, on the edge of a table, or on unstable surfaces.

• Do not expose the appliance to extreme temperatures, direct sunlight, or excessive humidity.

• Do not touch moving rotating parts during operation to avoid injury.

• Be careful when handling hot liquids and foods. Hot steam or splashing can cause scalding. Allow hot foods and liquids to cool to at least 45 °C before blending.

• The maximum operating time is 1 minute. Allow it to cool for 3 to 5 minutes before using again. For harder foodstuffs, interrupt operation after 30 seconds.

• Do not turn on the appliance when it is empty.

• Ensure the motor unit is off, unplugged, and rotating parts have stopped before disassembling.

• Do not use the appliance if it has been dropped, submerged in water, is not functioning correctly, or is damaged in any other way.

• Take special care when handling the blade assembly to avoid injury.

Rated voltage range: 220-240 V

Rated frequency: 50/60 Hz

Rated power input: 800 W

Electrical shock protection class: II

Noise level: 73 dB(A)

The declared noise emission level of the appliance is 73 dB(A), which represents a level A of acoustic power with respect to a reference acoustic power of 1 pW.

Explanation of Technical Terminology

Safety class for electrical shock protection:

Class II – Electrical shock protection is provided by double or heavy-duty insulation.

Packaging Materials:

Dispose of used packaging material at a site designated for waste in your municipality.

Used Electrical and Electronic Equipment:

The symbol of a crossed-out wheeled bin on the product or in its documentation means that used electric or electronic products must not be added to ordinary municipal waste. For proper disposal, renewal, and recycling, hand over these appliances to determined collection points. In some European Union states, you may return your appliances to the local retailer when buying an equivalent new appliance. Correct disposal of this product helps save valuable natural resources and prevents potential negative effects on the environment and human health. For more details, ask your local authorities or collection facility.