OMNITRONIC ED 100T (01) PDF DOCUMENT

Please adhere to the following safety guidelines when using the OMNITRONIC ED 100T:

• Only use the product according to the instructions given. Damages due to failure to follow these operating instructions will void the guarantee.

• Unauthorized rebuilds or modifications of the product are not permitted for reasons of safety and render the guarantee invalid.

• This product is not a toy. Keep it out of the reach of children. Do not leave packaging material lying around carelessly.

• This product is in accordance with protection grade IP44 and can be used in outdoor areas. However, do not immerse the product in water, as this will destroy it.

• Protect the product against excessive humidity and heat. The recommended temperature is -20 to +50°C.

• Never open the product. If this product is no longer working properly or is visibly damaged, take it out of operation and consult your local dealer. Do not attempt to repair the product yourself.

For a safe installation, please follow these rules:

• Make sure that the product is installed securely and cannot fall down. Serious injury to persons can be caused if the speakers fall down. Comply with the standards and rules that apply in your country.

• For commercial use, the country-specific accident prevention regulations of the government safety organization for electrical facilities must be complied with at all times.

• Speaker cables are sensitive to electrical interference. Hence, it is recommended to lay them at a distance of several meters to sources of interference (e.g. dimmers, light switches).

• Make sure that impedance and power rating specified in the technical data match the connected amplifier’s data. Otherwise, the speakers or the amplifier may be damaged. The total impedance for the connected speakers must not be less than the minimum impedance for the amplifier.

During operation, there is a hazard of contact with a voltage of up to 100 V at the connection wires. The installation must be carried out by skilled personnel only. Always insulate the connection cables which are not used. Observe the load of the PA amplifier by the speakers; an overload may damage the amplifier. The total power of all speakers connected must not exceed the amplifier power.

• Screw the horn driver via its 35 mm thread to the rear side of the horn speaker.

• Connect the speaker to the 70 V/100 V output of the PA amplifier using the correct polarity.

• Alternatively it is possible to connect the speaker to a low-impedance amplifier output.

• Adjust the rotary switch to the desired power rating.

• Never use the position 50 Ω (ED-100T) when operating the horn driver in a 70 V/100 V system. Otherwise damage may occur to the horn driver and amplifier.

• When connecting several horn speakers, make sure that all speakers have the same polarity and that the amplifier is not overloaded.

This product is maintenance-free, except for occasional cleaning. You can use a slightly dampened cloth for cleaning.

When to be definitively put out of operation, take the product to a local recycling plant for a disposal which is not harmful to the environment. Devices marked with this symbol must not be disposed of as household waste. Contact your retailer or local authorities for more information.