KOGAN KAPEPH15WPA (01) PDF MANUAL

KOGAN KAPEPH15WPA (01) PDF SUMMARY:

What should I do before using the heater?

Take the heater out of the box, remove the packaging, and check the installation parts.

How do I install the wheels?

Carefully turn the heater upside down, press the x4 wheels into the x2 wheel plates until they audibly click, then secure the wheel plates to the heater using x2 short screws per wheel plate. Finally, place the heater upright.

How do I wall mount the heater?

1. Drill x2 Ø8mm holes 220mm (1500W) or 500mm (2400W) apart, then drill a Ø8mm hole 25mm from the outer side of each hole.
2. Insert the x4 wall anchors into the drilled holes.
3. Secure x1 bracket to x2 wall anchors using x2 long screws, and repeat this to secure the other bracket to the other x2 wall anchors.
4. Locate the x2 holes in the back panel of the heater and secure the x2 spacers to the back panel using x2 short screws.
5. Hook the heater on the brackets.

What are the space requirements for mounting the heater?

There must be at least 200mm between the bottom edge of the heater and the floor. Other objects should be at least 200mm from the sides and 500mm in front of the heater.

Where should I NOT place the heater?

Do not place the heater under an electrical outlet, in a bathroom, or near a swimming pool.

What should I do before operating the heater?

Place the heater on a flat, stable surface and ensure the power knob is turned towards ‘off’.

How do I operate the heater?

1. Plug the heater into an electrical outlet.
2. Turn the power knob to the desired fan speed and the temperature knob to the desired temperature. The indicator will illuminate.
3. When the set temperature has been reached, turn the temperature knob anti-clockwise until it audibly clicks. All heating elements and the indicator will switch off.
4. The heater will automatically switch on when the ambient temperature decreases and will automatically switch off when the ambient temperature increases to maintain a comfortable ambient temperature.
5. Unplug the heater if it will not be used for a long time.

What should I do before cleaning the heater?

Wait until it cools down and unplug it.

How do I clean the heater?

Do not use abrasives and solvents. Wipe the heater with a soft, damp cloth, and remove dust from the surface of the heater regularly. Do not wash the heater or place it in water.

How should I store the heater?

If the heater will not be used for a long time, wipe the surface and store it in its original packaging in a dry, ventilated room. Do not expose the heater to humidity.