KIIROO PEARL2+ (PEARL2PLUS) (01) PDF Document

To set up and charge your KIIROO PEARL2+ (PEARL2PLUS), follow these steps:

1. Locate the charging port at the bottom of the device.

2. Insert the provided Pin USB charger into the small hole at the bottom of the KIIROO PEARL2+ (PEARL2PLUS).

3. Insert the other end of the cable into a USB port, such as on a computer or a wall adapter (please note that a wall adapter is not included in the box).

4. Wait for the red LED light to blink slowly, indicating that the device is charging.

5. Charge the device until the light turns solid green, which takes approximately 2 hours.

It is recommended to fully charge the KIIROO PEARL2+ (PEARL2PLUS) before its first use.

To operate the KIIROO PEARL2+ (PEARL2PLUS):

1. Power on: Press the multifunctional button at the bottom of the device and hold it for 4 seconds. A solid blue light will appear, indicating the device is in Bluetooth Mode.

2. Switch to Touch-Sensitive Mode: While the device is on, push the button once. The light will turn white.

3. Power off: Hold the multifunctional button for 4 seconds until the light goes off.

Please note that the KIIROO PEARL2+ (PEARL2PLUS) is waterproof and can be used in the bath or shower.

The KIIROO PEARL2+ (PEARL2PLUS) features 7 distinct modes that can be cycled through by clicking the single multifunctional button:

Bluetooth mode: 0 clicks (Indicated by a blue light). This is the only mode that allows sending and receiving signals to and from partners or content.

Touch-sensitive mode: 1 click (Indicated by a white light).

Slow vibration: 2 clicks.

Medium vibration: 3 clicks.

Fast vibration: 4 clicks.

Pattern 1: 5 clicks.

Pattern 2: 6 clicks.

Manual mode is indicated by a purple light, allowing you to click through the pre-set vibration modes.

In Touch-sensitive mode, indicated by a white light, the KIIROO PEARL2+ (PEARL2PLUS) responds intuitively to touch. The surface will vibrate whenever it comes into contact with your body. You can move the upper surface of the device over the clitoris for precise sensations or move the device deeper inside to have the entire shaft respond with widespread vibrations.

The LED indicator on the KIIROO PEARL2+ (PEARL2PLUS) provides the following status information:

Blue Light: Bluetooth mode.

White Light: Touch-sensitive mode.

Purple Light: Manual mode.

Solid Green Light: Battery is fully charged.

Slow Blinking Red Light: Device is currently charging.

Quickly Flashing Red Light: Battery is low. You will have approximately 5 minutes of use before the device disconnects from Bluetooth and turns off.

Continual Yellow Blinking: An update is available or an error has occurred.

Solid Yellow Light: The device is currently updating.

When using the KIIROO PEARL2+ (PEARL2PLUS), follow these handling guidelines:

Hold the device at the base and apply a generous amount of water-based lubricant. Using lubricant prolongs the lifespan of the device and ensures a comfortable experience.

Do not use silicone-based lubricants, as they will deteriorate the silicone material of the KIIROO PEARL2+ (PEARL2PLUS).

Do not use massage oils or hand creams as lubricants.

The KIIROO PEARL2+ (PEARL2PLUS) is intended for vaginal use only. It is not a hands-free device. Do not use the device anally as it does not have a tapered base and may get stuck.

To clean the KIIROO PEARL2+ (PEARL2PLUS), always clean it thoroughly after each use using warm water combined with antibacterial soap, dish soap, or a specialized toy cleaner.

Avoid using cleaners that contain alcohol, petrol, or acetone, and avoid harsh soaps, as these substances can damage the silicone. Do not use heating appliances to dry the device. Hygiene silicone is durable and will last for years if cared for properly.

Safety guidelines for the KIIROO PEARL2+ (PEARL2PLUS) include:

The device is not to be used by minors (anyone under 18) or anyone unable to express consent.

Do not use the device on inflamed or irritated areas.

Do not use the device if there are exposed electronic elements or if the device is excessively hot to the touch.

Avoid leaving the device in direct sunlight and never expose it to extreme heat.

Always store the KIIROO PEARL2+ (PEARL2PLUS) out of reach of children.

The Bluetooth module is located in the handle. For personal safety and optimal reception, avoid inserting the handle; only insert the top 13cm of the device.

This appliance contains non-replaceable batteries and is only to be used with the power supply unit provided.

The technical specifications for the KIIROO PEARL2+ (PEARL2PLUS) are as follows:

The KIIROO PEARL2+ (PEARL2PLUS) should not be disposed of in a standard waste bin. Because it contains a rechargeable battery and is used for intimate purposes, it must be disposed of according to local regulations for electronics and biowaste. Please consult your local council center for specific disposal instructions in your area.