Free English KEF CI200QS (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD KEF CI200QS (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
Who should perform the installation of the KEF CI200QS speaker?
Installation of the KEF CI200QS should be performed by an installer who is skilled in the proper use of hand and power tools, has knowledge of local building and fire codes, and is familiar with the environment behind the wall or ceiling where the speaker is being installed. No attempt should be made to install these loudspeakers unless you are sure you will not be cutting through electric cables, water or gas pipes, or supporting joists. You must also ensure the loading on the wall or ceiling will support the weight of the speaker assembly.
What types of environments is the KEF CI200QS designed for?
The KEF CI200QS has been designed for dry-lined, stud partition walls and ceilings, and for suspended ceilings.
How do I install the KEF CI200QS speaker?
Follow these steps to install your KEF CI200QS speaker:
Step 1. Using the supplied template, mark the cutout area on the installation surface.
Step 2. Carefully cut out the marked section of the wall or ceiling.
Step 3. Connect the speaker wires from your amplifier to the terminals on the speaker.
Step 4. Insert the speaker into the cutout opening. Turn the screws clockwise to engage the mounting clamps, securing the speaker firmly in place. Do not overtighten the screws.
Step 5. Attach the magnetic grille to the front of the speaker bezel.
Can I paint the grille of my KEF CI200QS?
Yes, the grille of the KEF CI200QS can be painted to match your decor. Follow these steps:
Step 1. Carefully remove the grille from the speaker.
Step 2. Apply a light coat of spray paint to the grille.
Step 3. Allow the paint to dry completely before reattaching the grille to the speaker.
Where should I place the badge on the KEF CI200QS grille?
To position the badge on the KEF CI200QS grille, align it with a corner. The recommended placement is 26mm from the outer edges of the grille.
What are the technical specifications for the KEF CI200QS?
| Model | Ci200QS |
| Series | Q Series |
| Nominal impedance | 8Ω |
| Sensitivity (2.83V/1m) | 90dB |
| Frequency response (±6dB) open-backed | 35Hz – 34kHz |
| Crossover frequency | 2.5kHz |
| Drive units | LF: 200mm (8in.) HF: 25mm (1in.) Uni-Q |
| Recommended amplifier power | 10 – 150 W |
| Product external dimensions (HxWxD) | 273 x 273 x 106 mm (10.75 x 10.75 x 4.17 in.) |
| Cut-out dimensions (HxW) | 238 x 238 mm (9.37 x 9.37 in.) |
| Net Weight | 2.4kg (5.3lbs.) |
| Mounting depth from surface | 99.8mm (3.93in.) |
| Optional rough in frame | RIF200S |
| Optional rear enclosure | RNC200S |
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
CLICK HERE TO DOWNLOAD KEF CI200QS (01) PDF DOCUMENT