Free English JVC CA-RC6 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD JVC CA-RC6 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
How do I position the JVC CA-RC6 cassette adaptor in my car audio system?
Position the cassette adaptor with side A facing up and set the play direction for the car audio system to the forward (FWD) direction.
Note that the head positions of the cassette adaptor and the car audio system do not match in the reverse direction, causing the sound volume from the speakers to be extremely low.
How do I adjust the cord position on the JVC CA-RC6 cassette adapter?
If the position of the cord coming out of the cassette adapter is adjusted using the groove provided on the back of the cassette, it will work with almost all car audio systems.
For a car audio system with the head at the right side, adjust the cord accordingly.
For a car audio system with the head at the left side, adjust the cord accordingly.
For a car audio system in which the head is in the center at the rear, adjust the cord accordingly.
How should I adjust the volume levels when using the JVC CA-RC6?
Adjust the volume level to the middle volume level for the CD player.
Adjust the volume level as desired for the car audio system.
What should I do if my car audio system has a blank skip function while using the JVC CA-RC6?
The blank skip function may operate when the CD player stops. Therefore, be sure to set the blank skip function to off.
How do I connect the car adaptor provided with the JVC CA-RC6?
The provided car adaptor must be connected. This car adaptor can be used in an automobile which has a 12 V battery (This is a negative ground car adaptor).
Do not connect the adaptor immediately after using the cigarette lighter.
Leave a little slack in the car adaptor’s cord, making sure that it does not run underneath the unit.
How do I replace the fuse in the car adaptor included with the JVC CA-RC6?
1. Remove the plug cap by rotating it in the direction shown by the arrow on the unit, and take out the old fuse.
2. Insert the new fuse (250 V, 1 A type) into the fuse receptacle and reinstall the plug cap.
Note: For continued protection against risk of fire, replace only with same type 250 V, 1 A fuse. If the fuse blows frequently, there may be something wrong with the adaptor. Consult your dealer.
What cautions should be followed when using the JVC CA-RC6 car adaptor?
The provided car adaptor is made specifically for use with DC 4.5V JVC portable CD players. Do not use it with other devices.
Do not use the adaptor for a long period with the batteries left in the unit because this may shorten the life of the batteries.
Pay attention to the car battery capacity when using this adaptor for a long period.
Do not expose this adaptor to strong sunlight or very high temperatures.
Be sure to remove this adaptor from the cigarette lighter socket when not using this adaptor or before leaving the automobile.
Check the DC IN jack for power source polarities.
How should I care for and maintain the JVC CA-RC6 cassette adaptor?
Bunch the excess cord together or place it so that it will not interfere with operation.
Do not touch the head or roller.
A protective film has been placed over the heads to prevent them from being damaged. Do not remove this film.
After use, remove the cassette adaptor and keep it so that no dust will adhere to the head section.
After installing the cassette adaptor in the car audio system, do not allow its cord to make contact with the control section.
The sound quality deteriorates when the head section of the car audio system becomes dirty. It is, therefore, a good idea to clean it periodically.
Do not leave this adaptor in a vehicle which is exposed to direct sunlight.
Do not bring any magnetized objects near this adaptor’s head position.
Because of the nature of its construction, the sound of something rotating can be heard in this adaptor. This is normal and not indicative of a malfunction.
During the winter months when the temperature inside the vehicle falls to an extremely low level, there may be times when the unit cannot be used because the cord is too stiff to allow the adaptor to be installed in its proper position.
If the pinch rollers or car audio capstan are dirty, it may no longer be possible to install the cassette adaptor in the car audio system. Clean the rollers and capstan using a cotton swab.
If the rollers are dirty, clean them using a cotton swab.
How do I troubleshoot problems with the JVC CA-RC6?
| Problem | Checkpoint | Remedy |
|---|---|---|
| The sound volume is extremely low. | Did you adjust the volume level of the unit? | Adjust the volume level of the unit to middle or higher. |
| Did you adjust the volume level of the car audio system? | Adjust the volume level of the car audio system to the desired level. | |
| Does the car audio system have an auto-reverse function? | Set the play direction for the car audio system to the forward (FWD) direction. [The forward (FWD) direction is the side which produces sound or which has the greatest sound volume.] | |
| The cassette adaptor cannot be inserted into the car audio system. | Did you check the position of the car audio’s head? | Check the position of the head in relation to the car audio system to ensure the cassette adaptor is installed correctly. |
| The unit cannot be turned on. | Is the fuse for the car adaptor blown? | Insert a new fuse. |
What are the specifications for the JVC CA-RC6 cassette and car adaptors?
Cassette adaptor
Frequency response: 30 Hz-20 000 Hz (This is the rating for the head section of the product.)
Dimensions (W × H × D): 102.4 mm × 12.1 mm × 63.8 mm
Mass: 38 g
Cable length: Approx. 1 m
Car adaptor
Input: DC 12 V
Output: DC 4.5 V (600 mA)
Dimensions (W × H × D): 90 mm × 40 mm × 26 mm
Cable length: More than 1.4 m
CLICK HERE TO DOWNLOAD JVC CA-RC6 (01) PDF DOCUMENT