IHOME POWERVALET SNAP IW23 (01) PDF DOCUMENT

1. Press & Hold the Time Set button to Set Clock.

2. Use the +/- buttons to select 12/24 hour mode and press the Time Set button to confirm.

3. Use the +/- buttons to set the hour and press the Time Set button to confirm. The PM Indicator will display for PM time. (There is no AM Indicator).

4. Use the +/- buttons to set the minute and press the Time Set button to confirm.

To Arm/Disarm the Alarm:

Press the Alarm Set button.

To Set the Alarm Time:

1. Press & Hold the Alarm Set button.

2. Use +/- to set the hour and press the alarm button to confirm.

3. Use +/- to set the minute and press the alarm button to confirm.

4. Use +/- to set the schedule (7 days, weekdays, weekends) and press the alarm button to confirm. The alarm is active for 7 days until a date is set.

When the Alarm Sounds:

Press the alarm button to disable it and reset it for the next day.

To Snooze the Alarm:

Press the Snooze/Dimmer button.

To Adjust Snooze Duration:

1. Press & Hold the Snooze/Dimmer button.

2. Use the +/- buttons to adjust the duration from 1-29 minutes.

3. Press the Snooze/Dimmer button to confirm.

To Adjust Display Brightness:

Press and release the Snooze/Dimmer button to cycle through the display options: Aut1, Aut2, Aut0, Hi, 3, 2, Lo, and OFF.

1. Press in and pull the battery door to open and remove it.

2. Install 2 new “AAA” batteries to maintain settings in case of a power failure, ensuring you match the (+/-) markings in the battery compartment.

3. Replace the door.

To Set the Date:

1. Press & Hold the Date Set button.

2. Use +/- to select the year and press the Date Set button to confirm.

3. Use +/- to set the month and press the Date Set button to confirm.

4. Use +/- to set the day and press the Date Set button to confirm.

To Manage DST:

A short press of the Date Set button will show the DST status on the display. Another short press toggles the Auto/OFF DST feature.

Connect the AC adapter to the DC Jack on the rear of the unit, and then plug the adapter into a wall outlet. The rear of the unit also features a USB-A (5W) and a USB-C (5W) charging port for additional devices.

Place your compatible device face up on the charging rest. The LED Status Indicator will show the charging status.

WARNING: Remove your phone’s metal protective case before charging. Do not place magnetic or metal objects on the charger during charging. Qi-compatible phones with metallic-looking finishes will charge normally.

Rapid blinking LED: The device is not charging. Please reposition the device.

Slow blinking LED: The device is currently charging.

Solid LED: The device is fully charged.

Magnetic Charging Works With: iPhone 12 and 13 series and newer MagSafe devices and cases, AirPods with a MagSafe case, or plastic cases up to 2mm thick.

Wireless Charging Works With: iPhone XS and iPhone 11 series, Samsung Galaxy S7 and newer wireless charging phones, and also works with a wireless charging case for AirPods and other wireless charging devices.

The built-in light sensor on the IHOME POWERVALET SNAP IW23 will automatically dim the clock display to match the light level of the surrounding environment when set to an ‘Auto’ brightness setting.

For the best performance, please follow these guidelines:

• Only use the recommended/supplied batteries or equivalent.

• Use alkaline batteries for longer life.

• Do not mix old and new batteries, and do not mix alkaline, carbon-zinc, or rechargeable nickel-cadmium batteries.

• Insert batteries with proper polarity (+/-) as indicated.

• Remove exhausted batteries from the product.

• Recharge rechargeable batteries under adult supervision.

• Do not attempt to recharge non-rechargeable batteries.

• Do not open batteries or heat them beyond normal ambient temperatures.

• To prevent battery leakage or damage, remove batteries from the product if it will not be used for a month or longer.

• Use extreme caution when handling leaking batteries (avoid direct contact with eyes and skin). If battery leakage comes in contact with eyes, IMMEDIATELY flush the eye with lukewarm and gently flowing water for at least 30 minutes. If skin contact occurs, wash skin with clean water for at least 15 minutes. Seek medical attention if any symptoms occur.

• Store in a cool, dry, ventilated area away from hazardous or combustible material.

• Follow applicable laws and local regulations for the disposal and transportation of batteries.

• Rechargeable batteries are to be removed from the product before being charged.

• The supply terminals are not to be short-circuited.

• Do not dispose of batteries in fire; batteries may leak or explode.

• CAUTION – RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. REPLACE ONLY WITH THE SAME OR EQUIVALENT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO THE INSTRUCTIONS.

Please heed all warnings, read and follow all instructions, and keep these instructions handy for future reference.

1. Do not use this product near water.

2. Unplug the unit and clean only with a damp cloth. Stronger cleaning agents, such as Benzene, thinner or similar materials can damage the surface of the unit.

3. Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions.

4. Heat – This product should be situated away from heat sources such as radiators, heat registers, stoves or other appliances (including amplifiers) that produce heat.

5. Only use attachments/accessories specified by the manufacturer.

6. Unplug this product during lightning storms or when unused for long periods of time.

7. This product should be serviced by qualified service personnel when: The plug has been damaged, objects have fallen into or liquid has been spilled into the enclosure, the unit has been exposed to rain, the unit has been dropped or the enclosure damaged, or the unit exhibits a marked change in performance or does not operate normally.

8. No naked flame sources, such as lighted candles, should be placed on this product.

9. Attention should be drawn to the environmental aspects of battery disposal.

10. This product is suitable for use in tropical and/or moderate climates.

WARNING: To reduce the risk of fire or electric shock, do not expose this product to rain or moisture. Do not dispose of batteries in the household trash or fire. The mains plug of the power adaptor is used as the disconnect device; it shall remain readily operable.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This equipment should be installed and operated with a minimum distance of 20cm (8 inches) between the radiator & your body.