HARMAN JBL STAGE1 62CF (01) PDF Document

The dimensions for the HARMAN JBL STAGE1 62CF components are as follows:

Woofer:

Cutout Diameter: 5-19/32″ (142mm)

Outer Diameter: 6-17/32″ (166.2mm)

Mounting Height: 2-3/16″ (55.4mm)

Total Height: 2-13/32″ (60.6mm)

Tweeter:

Diameter (with surface mount): 1-21/32″ (42mm)

Height (with surface mount): 1-29/32″ (48.4mm)

Diameter (tweeter only): 1-9/32″ (32.4mm)

Mounting Depth (surface mount): 5/8″ (15.6mm) and 15/16″ (23.4mm)

Mounting Depth (flush mount): 3/8″ (12.1mm) and 5/8″ (16.2mm)

The box for the HARMAN JBL STAGE1 62CF contains the following items:

2x Woofers

2x Tweeters

2x Tweeter surface mount housings

2x Tweeter flush mount housings

2x Crossovers

8x Screws

8x Speed clips

The connection for the HARMAN JBL STAGE1 62CF is made through the included crossover. The audio source wires connect to the input terminals on the crossover. The crossover then has separate output terminals to connect the woofer and the tweeter. Ensure the positive (+) and negative (-) terminals are connected correctly to maintain proper polarity.

The specifications for the HARMAN JBL STAGE1 62CF are:

Speaker: 6-1/2″ (165mm) Two-Way Component Car Speaker without Grille

Power Handling: *80W RMS, 640W peak

Sensitivity (@2.83V): 90dB

Frequency Response: 60Hz-20kHz

Nominal Impedance: 4ohm

*80W RMS: Long-term maximum power refer to IEC 60268

40W RMS: 100H continuous testing at rated power refers to IEC 60268

The Thiele-Small Parameters for the HARMAN JBL STAGE1 62CF woofer are as follows:

BL (Tm): 3.426

DCR (Ohms): 3.2

Mms (g): 11.32

Sd (cm²): 132.73

Cms (um/N): 409

Vas (L): 10.192

Fs (Hz): 74

Qes: 1.436

Qms: 8.488

Qts: 1.228

Crossover Point: 6400Hz