FRESH 'N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 (01) Image

Free English FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.


CLICK HERE TO DOWNLOAD FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 (01) PDF DOCUMENT

If this is not the document you want for this product, click here to see if we have any other documents for this product.

How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.

NO IMAGE CONTENT AT THIS TIME. PLEASE CHECK BACK LATER

What are the main controls on the side of the FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001?

The controls and ports located on the side of your FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 are as follows:

1. On/Off button

2. Bluetooth pairing button

3. LED indicator

4. Micro USB port (for charging)

5. Audio in port


What are the functions of the buttons on top of the FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001?

The functions for the top buttons on your FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 are:

1. **Volume down:** Press to decrease the volume.

2. **Multi-function button:**

– Short press: Play or pause the music.

– Short press: Take or end calls.

– Long press: Decline incoming calls.

3. **Volume up:** Press to increase the volume.


How do I charge my FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001?

To charge your FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001, connect it to a power source using the included Micro USB cable. The battery capacity LED will light up red while the speaker is charging. The LED will turn off when the speaker is fully charged.


How do I pair my FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 with my phone for the first time?

Follow these steps to pair your speaker:

1. Turn the speaker on using the on/off button located on the side.

2. Press the Bluetooth button once to activate Bluetooth pairing mode.

3. On your phone or other device, activate Bluetooth and select the speaker from the list of available devices.

4. You will hear a “bleep” to confirm that you are connected.


How do I use the “Double Fun Mode” to connect two FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 speakers?

Before you begin, deactivate Bluetooth on your phone, laptop, or tablet, and make sure both speakers are turned off.

1. **Turn on the first speaker:** You will find the on/off button on the side. Turn on the first speaker.

2. **Turn on the second speaker:** You will find the on/off button on the side. Turn on the second speaker.

3. **Prepare the first speaker for pairing:** You now need to set up the first speaker to pair with the second one. Press the Bluetooth button on the side of the first speaker once (a short press).

4. **Pairing the second speaker:** Press the Bluetooth button on the second speaker twice (two short presses). You will hear a “bleep” confirming that both speakers have been paired correctly.

5. **Turn on the Bluetooth on your phone/laptop/tablet:** Activate Bluetooth on your device and select the speaker from the list of available devices. You will hear a beep when you’re connected.


What should I do if my FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 has trouble connecting?

When you turn the FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 on, it will try to reconnect to the last device for 30 seconds. If it can’t find it, it will go into pairing mode for 3 minutes, allowing you to connect a new device. A soft reset, which involves turning your speaker off and on again, can sometimes resolve a pairing issue.


What if the pairing mode on my FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 is too slow or times out?

The speaker will stay in pairing mode for 3 minutes only. If you missed the window, press the Bluetooth button for 3 seconds to re-enter pairing mode.


How do I connect a different device to my FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001?

Press the Bluetooth button to set the speaker back into pairing mode, then you can connect a new device.


Why is my FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 beeping?

A beeping sound indicates that the battery is getting low. The FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 will provide a warning when the battery has 20, 15, and 10 percent capacity left.


Why did my FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 turn off unexpectedly?

If the speaker turned off, the battery level was below 5 percent. Charge the speaker to continue using it.


What should I do if my FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 went to sleep?

If you haven’t played anything in the last 30 minutes or forgot to turn your speaker off, it may enter a sleep mode. To continue playing music, turn your speaker off and then on again.


How do I ensure my FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 remains waterproof?

Your speaker is IPX7 certificated. To make sure that the FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 is waterproof, remove all cables from the speaker and close the rubber cover on the side. Exposing the speaker to liquids without doing this can cause permanent damage. Do not expose the speaker to water while charging, as this can cause permanent damage to the speaker or battery.

The speaker is defined as IPX7 because it can be immersed up to 1 meter deep in water for up to 30 minutes. The speaker does not like salt water. If the speaker comes into contact with salt water, it is advised to rinse the speaker with tap water to prevent salt from crystallizing on the drivers, controls, or fabric casing.


What are the important safety instructions for the FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001?

To ensure reliable operation, please follow these safety guidelines:

• Always follow all instructions and warnings closely.

• Read all instructions in the user manual carefully before operating the speaker.

• Do not attempt to modify or open the speaker. There are no serviceable parts inside.

• Do not operate the speaker in or near a significant heat source, heat vent, or under direct sunlight for long durations.

• The speaker should be used in an environment ranging from 5 °C – 45°C (41°F – 113°F).

• Do not cover the speaker with paper or other materials. This may affect its cooling capacity.

• Do not place heavy objects on the speaker.

• Do not attempt to push objects into openings of the speaker.

• Do not rely on your speaker for emergency communications.

• Keep your speaker away from medical devices, including pacemakers and hearing aids.

• Turn off your speaker in aircraft. Using your speaker in an aircraft might affect aircraft operations and might be illegal.

• Keep a minimum distance of 5 mm around the speaker for sufficient ventilation.

• No naked flame sources, such as lighted candles, should be placed on the speaker.

• Attention should be drawn to the environmental aspects of battery disposal.

• The battery shall not be exposed to excessive heat such as sunshine, fire or the like.

• The use of the product in tropical or moderate climates does not affect the device in anyway.

• CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.


What are the product specifications for the FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001?

• **Connectivity:** Bluetooth wireless

• **Audio Port:** Audio IN port (3.5mm)

• **Waterproofing:** IPX7

• **Wireless Playtime:** 12 hours

• **Charging Time:** Max. 1.5 hours

• **Special Features:** Double fun mode (pair two Bold S), Speakerphone function (built-in microphone)

• **Power Input:** DC input: 5V/1A max. (Micro USB)

• **Compatibility:** Compatible with iOS and Android

• **Weight:** 286 gram

• **Size:** 85 x 85 x 85 mm


CLICK HERE TO DOWNLOAD FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000MM V1 001 (01) PDF DOCUMENT


Leave comments, questions, reviews, tips, tricks, hacks or page errors below. Account not required.