FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000IG V1 001 (01) PDF Document

The main components and ports on the FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000IG V1 001 are as follows:

1. On/Off button

2. Bluetooth pairing button

3. LED indicator

4. Micro USB port

5. Audio in port

The buttons on your FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000IG V1 001 have the following functions:

1. Volume down: Decreases the volume.

2. Multi-function button:

Short press = play / pause music.

Short press = take / end calls.

Long press = decline calls.

3. Volume up: Increases the volume.

To charge your FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000IG V1 001, use the included Micro USB cable. The battery capacity LED will light up red while the speaker is charging. The LED will turn off when the speaker is fully charged.

Follow these steps to pair your FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000IG V1 001:

1. Turn the speaker on using the on/off button located on the side.

2. Press the Bluetooth button once to activate Bluetooth pairing mode.

3. Activate Bluetooth on your phone or other device and select the speaker from the list of available devices.

4. You will hear a “bleep” when your device is successfully connected.

Before you begin, deactivate Bluetooth on your phone/laptop/tablet and make sure both speakers are turned off.

1. Turn on the first speaker: You will find the on/off button at the side. Turn on the first speaker.

2. Turn on the second speaker: You will find the on/off button at the side. Turn on the second speaker.

3. Prepare the first speaker for pairing: To set up the first speaker to pair with the second speaker, press the Bluetooth button on the side of the first speaker once (short press).

4. Pairing the second speaker: Press the Bluetooth button on the second speaker twice (short presses). You will hear a “bleep” confirming that both speakers have been paired correctly.

5. Turn on the Bluetooth on your phone/laptop/tablet: Activate Bluetooth and select the speaker from the list of available devices. You’ll hear a beep when you’re connected.

When you turn the FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000IG V1 001 on, it will try to reconnect to the last device for 30 seconds. If it can’t find it, it will enter pairing mode for 3 minutes for you to connect a new device. A soft reset can sometimes resolve a pairing issue, so please try turning your speaker off and on again.

Your FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000IG V1 001 will stay in pairing mode for 3 minutes only. If you missed the window, press the Bluetooth button for 3 seconds to re-enter pairing mode.

To connect a new device, press the Bluetooth button on your FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000IG V1 001 to set it back into pairing mode.

A beeping sound indicates that the battery of your FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000IG V1 001 is getting low. You will receive a warning when the battery has 20, 15, and 10 percent capacity left.

The FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000IG V1 001 will automatically turn off if the battery was below 5 percent. Charge the speaker to use it again.

If you haven’t played anything for the last 30 minutes or forgot to turn the FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000IG V1 001 off, it may go into a sleep mode. To continue playing music, turn your speaker off and on again.

To ensure reliable operation of your FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000IG V1 001, please follow these safety guidelines:

• Always follow all instructions and warnings closely.

• Read all instructions in the user manual carefully before operating the speaker.

• The speaker is IPX7 certificated. To ensure it is waterproof, remove all cables and close the rubber cover on the side before exposing it to liquids. Do not expose the speaker to water while charging, as this can cause permanent damage.

• The speaker can be immersed in 1 meter deep water for up to 30 minutes.

• The speaker does not like salt water. If it comes into contact with salt water, rinse it with tap water to prevent salt from crystallizing on the drivers, controls, or fabric casing.

• Do not attempt to modify or open the speaker.

• Do not operate the speaker near a significant heat source or in direct sunlight for long durations.

• The speaker should be used in an environment ranging from 5 °C – 45°C (41°F – 113°F).

• Do not cover the speaker with paper or other materials.

• Do not place heavy objects on the speaker.

• Do not attempt to push objects into the openings of the speaker.

• Keep your speaker away from medical devices, including pacemakers and hearing aids.

• Turn off your speaker in aircrafts.

• Keep a minimum distance of 5 mm around the speaker for sufficient ventilation.

• No naked flame sources, such as lighted candles, should be placed on the speaker.

• The battery shall not be exposed to excessive heat such as sunshine, fire or the like.

• CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.