FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000DP V1 001 (01) PDF Document

The side panel of your FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000DP V1 001 features the following controls and ports:

1. On/Off button

2. Bluetooth pairing button

3. LED indicator

4. Micro USB port for charging

5. Audio in port

The buttons on top of the FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000DP V1 001 have the following functions:

1. **Volume down:** Decreases the volume.

2. **Multi-function button:**

• Short press: Play or pause music.

• Short press: Take or end calls.

• Long press: Decline calls.

3. **Volume up:** Increases the volume.

Follow these steps to set up your FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000DP V1 001:

Step 1. **Charge the speaker:** Use the included Micro USB cable to charge the speaker. The battery capacity LED will light up red while charging and turn off when fully charged.

Step 2. **Turn the speaker on:** Locate the on/off button on the side of the speaker and turn it on.

Step 3. **Activate Bluetooth:** Press the Bluetooth button once to activate Bluetooth pairing mode.

Step 4. **Connect your phone:** Activate Bluetooth on your phone or other device and select the speaker from the list of available devices. You will hear a “bleep” when it’s successfully connected.

Before you start, make sure Bluetooth is deactivated on your phone/laptop/tablet and both speakers are turned off. Then, follow these steps:

Step 1. **Turn on the first speaker:** Use the on/off button on the side to turn on the first speaker.

Step 2. **Turn on the second speaker:** Use the on/off button on the side to turn on the second speaker.

Step 3. **Prepare the first speaker for pairing:** Press the Bluetooth button on the side of the first speaker once (a short press).

Step 4. **Pair the second speaker:** Press the Bluetooth button on the second speaker twice (two short presses). You will hear a “bleep” confirming that both speakers have paired correctly.

Step 5. **Turn on Bluetooth on your device:** Activate Bluetooth on your phone, laptop, or tablet and select the speaker from the list of available devices. You will hear a beep when you are connected and can now listen in Double Fun Mode.

When you turn the FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000DP V1 001 on, it will try to reconnect to the last device for 30 seconds. If it fails, it will enter pairing mode for 3 minutes for you to connect a new device. A soft reset can sometimes resolve a pairing issue, so please try turning your speaker off and on again.

If you miss the 3-minute pairing mode, press the Bluetooth button for 3 seconds to re-enter pairing mode.

To connect a new device, press the Bluetooth button to set the speaker back into pairing mode.

A beeping sound indicates that the battery is getting low. The FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000DP V1 001 will provide a warning when the battery capacity is at 20, 15, and 10 percent.

The speaker turned off because the battery level was below 5 percent. Charge the speaker to continue using it.

If you haven’t played anything in the last 30 minutes or forgot to turn the speaker off, it may enter a sleep mode. To continue playing music, turn your speaker off and on again.

The speaker is defined as IPX7 because it can be immersed in up to 1 meter of water for up to 30 minutes.

To make sure that the Rockbox Bold is waterproof, remove all cables from the speaker and close the rubber cover on the side. Exposing the speaker to liquids without doing this can cause permanent damage to the speaker. Do not expose the speaker to water while charging, as this can cause permanent damage to the speaker or battery.

The FRESH ‘N REBEL ROCKBOX BOLD S 1RB6000DP V1 001 does not like salt water. If the speaker comes into contact with salt water, it is advised to rinse the speaker with tap water. This will prevent salt from crystallizing on the drivers, controls, or fabric casing.