Free English ELECTRO-VOICE MB1082 (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD ELECTRO-VOICE MB1082 (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How do I install the ELECTRO-VOICE MB1082 mounting bracket kit for a wall or ceiling?
To mount the ELECTRO-VOICE MB1082, please follow these steps:
1. Attach the U-bracket (A) to the wall or ceiling using fasteners that are suitable for the wall or ceiling material (not supplied).
2. Remove the paper backing from the friction pads (C) and attach these to the U-bracket as shown in the installation figure.
3. Remove the two 3/8-16 bolts from each end of the enclosure.
4. Ensuring that the washer (B) is mounted between the U-bracket and the 3/8-16 screw(s) previously removed from the enclosure, mount the Xi-1082 speaker to the U-bracket by selecting two of the six available mounting holes on the bracket.
5. Rotate the speaker so that the input terminal is accessible and attach the wires. Position the speaker for the desired angle and tighten the screws sufficiently so that the speaker does not inadvertently rotate.
What is the important safety caution I should be aware of when installing the ELECTRO-VOICE MB1082?
Due to the weight of the Xi-1082 speaker system, it is imperative that the ELECTRO-VOICE MB1082 bracket be properly secured to the wall or ceiling. The choice of fastener, which is not provided with the bracket kit, will be determined by the material and construction of the mounting surface.
What parts are included with the ELECTRO-VOICE MB1082 mounting bracket kit?
The ELECTRO-VOICE MB1082 mounting bracket kit includes the following parts:
| Item | Qty. | Part No. | Description |
|---|---|---|---|
| A | 1 | 74120-JF/JH | U-Bracket Blk/Wht |
| B | 2 | 4053 | Washers |
| C | 2 | 38020 | Friction Pads |
What are the specifications for the ELECTRO-VOICE MB1082 mounting bracket?
| Wall/Ceiling Mounting Holes | Three in-line, 0.40″ (10mm) diameter clearance holes, centers spaced 6.8″ (173mm) apart |
| Enclosure Mounting Holes | Six 0.40″ (10mm) diameter clearance holes on the ends of the bracket |
| Material | Hot-rolled steel |
| Finish | Black or White powder coat |
| Parts Supplied | U-bracket, (2) Friction pads, (2) Washers |
| Net Weight | 2.25 lbs (1.02 kg) |
| Shipping Weight | 3.25 lbs (1.47 kg) |
| Part Numbers | 7003244 (BLK) 7003402 (WHT) |
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
CLICK HERE TO DOWNLOAD ELECTRO-VOICE MB1082 (01) PDF DOCUMENT