SKYLINK SL300R (01) PDF Document

Both the transmitter and receiver for your SKYLINK SL300R are built-in with a dip switch to enable users to choose their own codes. From the factory, the odd numbers of the dip switch are pre-set to the “ON” position, and even numbers are set to the “OFF” position. It is recommended that a different code be set for both the transmitter and receiver after installation.

Your SKYLINK SL300R receiver is a universal radio digital receiver with an operating voltage from 18V to 30V AC or DC, supplied by the garage or gate operator.

Code Setting:

Remove the front lower cover of the receiver case. Set the code of the dip switch, then replace the cover after setting the code.

Wiring Connection:

White wire – connect to common

Red wire – connect to 24V

Black Wire – relay output, connect to relay

Antenna Wire:

Please DO NOT remove the yellow wire. Ensure that it is in an up-right position to receive data signals from the transmitter.

Operating Source:

The transmitter is operated by a 12V Alkaline battery (#23A).

Code Setting:

The transmitter has a built-in dip switch.

1. Remove the battery cover.

2. Set the code of the dip switch of the transmitter to match the code of the SKYLINK SL300R receiver.

3. Replace the battery cover after testing the transmitter with the receiver.