ASUS PRIME CASE AP202 (01) PDF DOCUMENT

The accessory kit for the ASUS PRIME CASE AP202 includes the following items:

The side panels of the ASUS PRIME CASE AP202 can be removed without tools. To remove a side panel, simply pull it away from the top of the chassis and then lift it off. Repeat the process for the other side panel.

Note: The glass panel should be handled with care.

To install the PSU in the ASUS PRIME CASE AP202, follow these steps:

1. Slide the Power Supply Unit into the designated PSU bay at the bottom rear of the case.

2. Secure the PSU to the chassis from the rear using the four included PSU screws (labeled as ‘A’ in the accessory kit).

Before installing the motherboard into the ASUS PRIME CASE AP202, you should first install the CPU cooler and the RAM modules onto the motherboard.

To install the motherboard in the ASUS PRIME CASE AP202, first install the I/O shield into the rectangular cutout at the rear of the case. Then, carefully place the motherboard assembly into the case, aligning the motherboard’s ports with the I/O shield and the screw holes with the standoffs. Secure the motherboard using eight of the provided Motherboard screws (labeled ‘C’ in the accessory kit).

Connect the front panel cables from the ASUS PRIME CASE AP202 to the corresponding headers on your motherboard. The connectors include:

• Power button and LEDs (typically labeled F_PANEL)

• HD Audio

• USB Type-C

• USB 3.0

To synchronize the lighting of the ASUS PRIME CASE AP202, connect the case’s ARGB cable to the addressable RGB (ARGB) header on a compatible motherboard.

1. Remove the screws holding the PCI-E slot cover that corresponds to the slot you wish to use on your motherboard. Remove the cover.

2. Insert the PCI-E card firmly into the slot on the motherboard and secure it using the screws you previously removed.

1. Pull the drive tray out from its cage inside the case.

2. Secure your drive to the tray using the appropriate screws:

• For a 2.5-inch drive, use the Motherboard / 2.5″ Drive Screws (labeled ‘C’).

• For a 3.5-inch drive, use the 3.5″ Drive Screws (labeled ‘B’).

3. Slide the tray with the installed drive back into the drive cage until it clicks into place.

The ASUS PRIME CASE AP202 is equipped with dust filters on the top and bottom of the chassis. To install or remove them for cleaning, simply lift the top filter off or slide the bottom filter out from the rear of the case.

The maximum height for a CPU cooler in the ASUS PRIME CASE AP202 is 175mm.

The maximum length for a graphics card in the ASUS PRIME CASE AP202 is 420mm.

The ASUS PRIME CASE AP202 supports the following fan configurations:

• Up to nine 120mm fans.

• Up to two 140mm fans.

The ASUS PRIME CASE AP202 supports the following radiator sizes for water-cooling:

• 120mm

• 240mm

• 360mm

For a water-cooling setup in the ASUS PRIME CASE AP202, the thickness limitations are:

• 30mm MAX

• 25mm MAX

These values likely refer to the combined thickness of the radiator and fans in different mounting locations.

Accessories that came with this product have been designed and verified for use in connection with this product. Never use accessories for other products to prevent the risk of electric shock or fire.