ALLIANCE ZWN63RSN116CW01 (01) PDF Document

To enter the Factory Test Procedure for the ALLIANCE ZWN63RSN116CW01, follow these steps:

1. Disconnect electrical power from the unit.

2. Reconnect electrical power to the unit.

3. Wait about 10 seconds.

4. Turn the Cycle Selection knob to the opposite of Normal Eco and stay on that selection for at least one second.

5. Press and hold the Start/Pause button.

6. Change the Cycle Selection knob to Normal Eco within 5 seconds.

7. Stay on Normal Eco for at least one second. The control will then enter the Factory Test Mode.

8. Press the Start/Pause button to advance through the sequence of test steps.

To advance the ALLIANCE ZWN63RSN116CW01 to the final drain and spin step, ensure that the EXTRA RINSE setting is in the OFF position. Then, press and hold the START/PAUSE button. After about three seconds, the current cycle status light will turn off. Continue holding the START/PAUSE button for another 7 to 8 seconds until the SPIN light comes on, then release the button. If the lid was unlocked, the LID LOCK light will come on, the lid will lock, and the machine will start to drain and spin.

For end of cycle audio signals on the ALLIANCE ZWN63RSN116CW01, hold the Extra Rinse button for three seconds to turn the signal off or on. A one-second tone will sound to confirm the change.

To turn off audio signals that sound when a knob selection is changed or when buttons are pressed, hold the Extra Rinse button for 10 seconds. Hold it again for 10 seconds to turn the signals back on. A three-second tone will confirm the setting change, and the status lights will indicate the change by lighting in an upward pattern when turned on or a downward pattern when turned off.

Follow these steps to level your ALLIANCE ZWN63RSN116CW01:

1. Place a level on the cabinet top and check if the washer is level from side to side and front to back.

2. If the washer is not level, tilt the washer back to access the front leveling legs. Loosen the locknuts and adjust the legs by screwing them into or out of the washer base.

3. Once adjusted, tilt the washer forward on the front legs and lower it back down into position to set the rear self-leveling legs.

4. Ensure the washer does not rock. Once level and stable, tighten the locknuts securely against the bottom of the washer base.

If the WASH and RINSE LEDs flash once during the first fill on the ALLIANCE ZWN63RSN116CW01, it may indicate the pressure sensor harness was installed incorrectly. Follow these steps to correct it:

1. Disconnect electrical power from the unit.

2. Remove the screws holding the hood assembly to the rear hood panel.

3. Tip the control panel down to locate the H7 connection block (a 4-pin block with white, red, and gray wires).

4. Press the connection block release arm and remove the block.

5. Relocate the connection block so the release arm is at the three o’clock position, matching the lock tab on the control.

6. Re-install the control hood, reconnect electrical power, and run a cycle to verify operation.

When replacing or reinstalling the drive bell on the ALLIANCE ZWN63RSN116CW01, use the following torque specifications: