3SIXT KICK 3S-0337 (01) PDF Document

You should fully charge your 3SIXT KICK 3S-0337 for at least 2 hours through a wall outlet before its first use.

To recharge your 3SIXT KICK 3S-0337, insert the supplied USB 2.0 cable (micro USB end) into the speaker’s 5V input port. Insert the other USB end of the cable into the USB 2.0 port of your wall adaptor, laptop, or PC.

1. Enable Bluetooth on your device (e.g., smartphone or tablet).

2. Slide the Power Button on the speaker to ‘ON’. It will make a sound and the Bluetooth/Speakerphone button will flash blue.

3. Hold down the Bluetooth/Speakerphone button for 4 seconds and wait for a tone.

4. The speaker should appear in your device’s paired devices list. ‘Pair’ your device with the speaker.

5. The speaker will then make another tone to confirm the pairing.

You can now play music and audio through the speaker. Adjust the volume through your device’s volume settings.

For every pairing after your first, you only need to turn on your device’s Bluetooth, turn on the speaker, and hold down the Bluetooth/Speakerphone button for 4 seconds.

The controls for Bluetooth audio are as follows:

• Press the Bluetooth/Speakerphone button for four seconds to enter Bluetooth Mode.

• Press the Bluetooth/Speakerphone button for 1 second to pause/play.

• When the speaker is in standby, press the Bluetooth/Speakerphone button for 4 seconds to change between Bluetooth and AUX Mode.

The speakerphone functions are:

• Press the Bluetooth/Speakerphone button to pick up or hang up an incoming call (while in Bluetooth Mode only).

• Press the Bluetooth/Speakerphone button for 2 seconds to reject a call.

The Bluetooth transmission range or connectivity could be affected by low battery power. In that case, recharge the speaker immediately.

Please adhere to the following safety information:

1. Before recharging through a wall outlet, make sure the wall outlet voltage is 5V.

2. Use a standard USB 2.0 Charge & Sync Cable with the appropriate specifications. Other cables may cause damage.

3. Do not drop, knock, disassemble, or attempt to repair the speaker.

4. Do not immerse or put the speaker in water and keep it in a dry place.

5. Do not expose the speaker to excessive heat, including sunlight and fire.

6. Do not use the speaker near explosive gases or flammable materials.

7. Do not burn or incinerate the speaker.

8. Do not expose the speaker to harsh chemicals.

9. Turning the volume up to the maximum shortens the life of the speaker and may also damage your hearing.

10. Putting anything other than a standard USB 2.0 charge & sync cable into the input or output ports will cause damage or short out the speaker.

11. If you encounter any fault during operation, please cut off the power supply and disconnect the USB cable to prevent further damage.