3SIXT KICK 3S-0338 (01) PDF Document

You should fully charge your 3SIXT KICK 3S-0338 for at least 2 hours through a wall outlet before using it for the first time.

To recharge your 3SIXT KICK 3S-0338, follow these steps:

1. Insert the supplied USB 2.0 cable (micro USB end) into the speaker’s 5V input port.

2. Insert the other USB end of the cable into the USB 2.0 port of your wall adaptor, laptop, or PC.

1. Enable Bluetooth on your device (e.g., smartphone or tablet).

2. Slide the Power Button on the speaker to ‘ON’. It will make a sound and the Bluetooth/Speakerphone button will flash blue.

3. Hold down the Bluetooth/Speakerphone button for 4 seconds and wait for a tone.

4. The speaker should appear in your device’s paired devices list. Select ‘Pair’ to connect your device with the speaker.

5. The speaker will then make another tone to confirm the pairing. You can now play music and audio through the speaker. Adjust the volume through your device’s volume settings.

For every pairing after your first, you only need to turn on your device’s Bluetooth, turn on the 3SIXT KICK 3S-0338, and hold down the Bluetooth/Speakerphone button for 4 seconds.

• Press the Bluetooth/Speakerphone button for four seconds to enter Bluetooth Mode.

• Press the Bluetooth/Speakerphone button for 1 second to pause/play.

• When the speaker is in standby, press the Bluetooth/Speakerphone button for 4 seconds to change between Bluetooth and AUX Mode.

• To pick up or hang up an incoming call (while in Bluetooth Mode only), press the Bluetooth/Speakerphone button.

• To reject a call, press the Bluetooth/Speakerphone button for 2 seconds.

1. Before recharging through a wall outlet, make sure the wall outlet voltage is 5V.

2. Make sure to use a standard USB 2.0 Charge & Sync Cable with the appropriate specifications. Other cables may damage your smartphone, tablet, or the speaker.

3. Do not drop, knock, disassemble, or attempt to repair the speaker.

4. Do not immerse or put the speaker in water and keep it in a dry place.

5. Do not expose the speaker to excessive heat, including sunlight and fire.

6. Do not use the speaker near explosive gases or flammable materials.

7. Do not burn or incinerate the speaker.

8. Do not expose the speaker to harsh chemicals.

9. Turning the speaker’s volume up to the max shortens its life. It may also damage your hearing.

10. Putting anything in the speaker’s input or output ports, other than a standard USB 2.0 charge & sync cable, will cause damage or short out the speaker.

11. When encountering any fault during operation, please cut off the power supply and disconnect the USB cable to prevent further damage to the speaker or other components.

12. The Bluetooth transmission range or connectivity could be affected by low battery power. In that case, recharge immediately.