WISBERG WBSBSIW177CZ (01) PDF Document

1. Unpack: Remove packaging materials and check that the WISBERG WBSBSIW177CZ is not damaged. Do not connect it if damaged.

2. Location: Ensure the location is well ventilated. Move the appliance with two people. Do not place near heat sources or in direct sunlight. Do not use outdoors.

3. Installation: Ensure there is at least 10 cm clearance on the top, 10 cm on both sides, and 10 cm at the back. Use the front adjusting legs to level the appliance. Place on a firm, flat surface. If on carpet, straw mats, or PVC, place a solid sheet underneath to prevent color change.

4. Clean: Clean the interior and accessories with lukewarm water and neutral soap, then dry carefully.

5. Wait: On first installation, wait at least four hours before plugging in to allow the oil to flow back into the compressor.

6. Switch on: Check that voltage and frequency match the type plate. Connect to an earthed socket. After one hour, check if the temperature is noticeably lower.

Open the door and loosen the locking nut with an adjustable spanner. To raise the door, turn the adjusting nut clockwise. To lower the door, turn the adjusting nut anticlockwise. Once both doors are aligned straight, tighten the locking nut by turning it anticlockwise.

1. Slide the water tank out of the WISBERG WBSBSIW177CZ. 2. Open the water inlet cover on the tank. 3. Add drinking water or alkaline water, ensuring you do not exceed the maximum level. 4. Close the inlet cover. 5. Push the water tank back into the refrigerator until it is securely in place. Wait 30 seconds after re-inserting before taking the first glass of water.

Press the TEMP. SELECT button to toggle between the refrigerator and freezer. Once the desired icon illuminates and the display flashes, use the + and – buttons to adjust the temperature. The setting is confirmed once the display is locked. The refrigerator can be set between 2 and 8 degrees, and the freezer between -16 and -24 degrees.

Press the Mode Select button to select the ‘Super Cool’ mode. The indicator will appear on the display. The refrigerator will be additionally cooled to 2 degrees for six hours. This mode switches off automatically after six hours. To deactivate it manually, press the Mode Select button again.

Press the Mode Select button to select the ‘Super Freeze’ mode. The indicator will appear on the display. The freezer will be additionally cooled to -24 degrees. This mode switches off automatically after 40 hours. To deactivate it manually, press the Mode Select button again.

The WISBERG WBSBSIW177CZ operates optimally within specific ambient temperatures based on its climate class:

SN: +10°C to +32°C

N: +16°C to +32°C

ST: +16°C to +38°C

T: +16°C to +43°C

Check the following: 1. Ensure the temperature control knob is not set incorrectly. 2. Verify the plug is inserted properly into the socket. 3. Check if there is voltage at the socket (e.g., check if the interior lamp turns on). 4. Check for a blown or defective fuse. 5. Ensure the ambient temperature is not below 10°C. 6. Check if the holiday mode is enabled and deactivate it if necessary.

Check that the WISBERG WBSBSIW177CZ is standing stable and level. Adjust the leveling legs if necessary. Also, ensure the appliance is not in contact with the wall or other objects.

1. Switch off the ice-making function. 2. Hold the ice dispenser with both hands and gently pull it free, removing the ice container from the door. 3. Empty the contents. 4. Clean the dispenser if necessary. 5. Replace the dispenser, ensuring it is securely in place; if it does not fit, turn the gear at the back of the dispenser to the correct position and try again.