WHEREVER LITE WL-12 (01) PDF Document

If your WHEREVER LITE WL-12 causes harmful interference to radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

• Remove batteries if left unused for long periods.

• Do NOT use different types of batteries at the same time.

• Do NOT mix alkaline, standard (carbon-zinc) or rechargeable (nickel-cadmium) batteries.

• Only recommended batteries are to be used.

• Alkaline batteries are recommended for best use.

• Do NOT use new and old batteries at the same time.

• Do NOT attempt to re-charge non-rechargeable batteries.

• Rechargeable batteries are only to be charged under adult supervision.

• Be sure to install batteries with the polarities aligned correctly.

• When batteries are exhausted, remove them to prevent damage or danger.

• Do NOT attempt to short circuit the terminals.

• Do NOT dispose of in a fire as batteries may explode or leak.

1. Locate the battery compartment on the back of the remote.

2. Place 2 “AAA” batteries inside, making sure the polarities are properly matched. Match “+” and “-” symbols that are on the battery ends to the marks inside the battery compartment.

3. Replace and close the cover.

1. Locate the battery compartment on the bottom of the light. Turn the cover counter-clockwise and remove.

2. Place 3 “AA” batteries inside, making sure the polarities are properly matched. Match “+” and “-” symbols that are on the battery ends to the marks inside the battery compartment.

3. Replace cover and turn clockwise to close.

You can program the Wireless Remote Control to operate multiple WHEREVER LITE WL-12 units from the press of a button. For individual use, the light is ready to use out of the box with its remote.

GROUP SETUP:

1. On the back of the Wireless Remote Control, locate the code switch.

2. Flip the switches to a combination of your choice.

3. On the back of your Wherever Lite, open the battery compartment cover and locate its code switch.

4. Flip the switches to match the combination code that you entered on your Remote.

5. Replace the battery compartment cover and repeat the process with the rest of the Wherever Lites in the grouping.

NOTE: It is not recommended to exceed 20 lights per grouping.

WIRELESS REMOTE CONTROL: Use the “keyhole” on the back of the remote to screw mount, OR, peel off the adhesive paper on the back and stick it to the desired location.

WHEREVER LITE: Remove the battery compartment on the back of the Wherever Lite and attach it to the desired location using screws, OR peel and stick on the back and stick it to the desired location.

1. To turn the light on, you can either switch the remote to the “On” position, OR you can simply press the center of the Wherever Lite.

2. To dim the light, simply press and hold the “On” position on the remote.

3. To turn the light off, either switch the remote to the “Off” position, OR press the center of the light.

On the side of the Wireless Remote Control there is a switch for three built-in timer functions. By choosing one of these settings, your light will automatically shut off after either 15 minutes or 30 minutes to preserve battery life.