TIMAGO BLUE-TIM (01) PDF DOCUMENT

The TIMAGO BLUE-TIM set includes: chair frame, backrest, armrests (2pcs), legs (4 pcs), locking clips for legs (4 pcs), locking knobs (6 pcs), soft seat, and a sanitary container.

The elements of the TIMAGO BLUE-TIM commode chair are:

A. backrest

B. frame

C. legs

D. anti-sliding tips

E. sanitary container

F. armrests

G. upholstered seat

The TIMAGO BLUE-TIM commode chair is ancillary equipment which helps the user to perform hygienic activities. The chair is recommended for people with dysfunctions and reduced mobility who have problems with unassisted walking and for those who lost the ability of unassisted sitting down and standing up. The chair functions as a toilet owing to the toilet bucket located under the seat. The chair facilitates performing physiological activities and taking care of the user.

Step 1: Turn the chair frame upside down and insert the four legs into the mounting holes. Tighten them using the mounting knobs.

Step 2: Adjust the legs to the desired height and secure them using locking clips.

Step 3: Turn the chair upright and place it on the ground.

Note: All four legs must be adjusted to the same height and rest firmly on the ground for stability.

Step 4: Insert the backrest into the chair frame and tighten it using the two locking knobs.

Step 5: Place each armrest onto the armrest frame so that it fits into the groove and extends outward. Important: Do not install the armrests in reverse, as this will reduce the seat width between them. Once properly positioned, secure each armrest from underneath using Allen screws.

Step 6: Slide the sanitary container along the guides located under the seat.

Step 7: Place the upholstered seat cushion on top of the toilet seat.

To adjust the height of the chair, pull out the locking clips, select the desired height and lock the set height afterwards. The legs are adjustable in increments of 2,5 cm.

Note: all legs must be set at the same level. All legs should stand firmly on the ground.

Lift the soft seat, and remove the lid of the sanitary container. After use, cover the container with the lid and place the soft seat on the toilet seat.

Note! Remember to empty the toilet sanitary container after each use.

Carry out regular maintenance of the technical condition of the chair:

• Clean the commode chair regularly using only water and mild detergents. Dry thoroughly.

• Do not use for cleaning: strong polishing agents and detergents, abrasive agents, bleach, petrol or solvents (it may cause frame damage, visible defects and in consequence – loss of warranty rights).

• Empty and disinfect the sanitary container and the toilet seat after each use.

The product should not be exposed to direct sunlight, water or moisture.