SONY BRAVIA KDL-65W955B (01) PDF Document

To replace the fuse on your SONY BRAVIA KDL-65W955B, open the fuse compartment with a blade screwdriver and replace the fuse. A moulded plug complying with BS1363 is fitted for your safety. If the fuse needs to be replaced, you must use one with the same rating approved by ASTA or BSI to BS 1362. If the plug has a detachable fuse cover, ensure you reattach it after changing the fuse. Never use the plug without the fuse cover.

When transporting your SONY BRAVIA KDL-65W955B television, please follow these guidelines for safety:

• Before moving the TV, disconnect all cables.

• Transporting a large TV set requires two or three people.

• When carrying the TV by hand, hold it from the bottom and sides. Do not put stress on the LCD panel or the frame around the screen.

• Avoid subjecting the TV to jolts or excessive vibration during transport.

• If you need to transport the TV for repairs or when moving, pack it using the original carton and packing material.

To ensure proper ventilation for your SONY BRAVIA KDL-65W955B and prevent overheating, leave adequate space around the television as specified below. Never cover the ventilation holes or insert anything into the cabinet.

Installed on the wall:

• Leave at least 30 cm of space above the TV.

• Leave at least 10 cm of space on the left, right, and bottom of the TV.

Installed with stand:

• Leave at least 30 cm of space above the TV.

• Leave at least 10 cm of space on the left and right sides of the TV.

• Leave at least 6 cm of space behind the TV.

To prevent the collection of dirt or dust:

• Do not lay the TV set flat, or install it upside down, backwards, or sideways.

• Do not place the TV on a shelf, rug, bed, or in a closet.

• Do not cover the TV with a cloth, such as curtains, or items like newspapers.

When attaching the Wall-Mount Bracket to your SONY BRAVIA KDL-65W955B, you must use the screws supplied with the Wall-Mount Bracket. The supplied screws are designed to be 8 mm – 12 mm in length when measured from the attaching surface of the Wall-Mount Bracket. The diameter and length of the screws differ depending on the specific Wall-Mount Bracket model. Using screws other than those supplied may result in internal damage to the TV set or cause it to fall.

To avoid any risk of fire, electrical shock, or damage, handle the mains lead and socket for your SONY BRAVIA KDL-65W955B as follows:

• Use only mains leads supplied by Sony, not other suppliers.

• Insert the plug fully into the mains socket.

• Operate the TV on a 220-240 V AC supply only.

• When wiring cables, unplug the mains lead for your safety and be careful not to catch your feet on the cables.

• Disconnect the mains lead before working on or moving the TV.

• Keep the mains lead away from heat sources.

• Unplug the mains plug and clean it regularly.

• Do not use the supplied mains lead on any other equipment.

• Do not pinch, bend, or twist the mains lead excessively.

• Do not modify the mains lead.

• Do not put anything heavy on the mains lead.

• Do not pull on the mains lead itself when disconnecting it.

• Do not connect too many appliances to the same mains socket.

• Do not use a poor fitting mains socket.

Before cleaning your SONY BRAVIA KDL-65W955B, be sure to unplug the mains lead from the mains socket. To avoid material degradation, observe the following precautions:

1. To remove dust from the screen surface or cabinet, wipe gently with a soft cloth.

2. If dust is persistent, wipe with a soft cloth slightly moistened with a diluted mild detergent solution.

Important Precautions:

• Never spray water or detergent directly on the TV set. It may drip to the bottom of the screen or exterior parts and cause damage.

• Never use any type of abrasive pad, alkaline/acid cleaner, scouring powder, or volatile solvent, such as alcohol, benzene, thinner, or insecticide. Using such materials or maintaining prolonged contact with rubber or vinyl materials may result in damage to the screen surface and cabinet material.

• Periodic vacuuming of the ventilation openings is recommended to ensure proper ventilation.

• When adjusting the angle of the TV, move it slowly to prevent it from moving or slipping off its table stand.

You can change the Table-Top Stand on your SONY BRAVIA KDL-65W955B from the edge position to the middle position. This installation requires two or more people. The torque for the screws should be approximately 1.5 N·m {15 kgf·cm}.

1. Place the TV on a thick cushion. Remove the screws from the stand legs at the edge positions.

2. Re-attach the stand legs to the middle positions using the screws you just removed.

The Touchpad Remote Control can only be used after it has been registered with your SONY BRAVIA KDL-65W955B television.

To register the remote:

1. Press the HOME button.

2. Select [Settings] → [System Settings] → [Touchpad Remote Control Setup].

To display the Operation Guide:

The Touchpad Operation Guide shows the main gesture commands available. To display it, touch and keep your finger on the center of the touchpad.

You can launch the Touchpad Tutorial on your SONY BRAVIA KDL-65W955B by following these steps:

1. Press the HOME button on your remote.

2. Slide to select [Help], then press the touchpad.

3. Slide up/down to select [Touchpad Tutorial], then press the touchpad.

4. Follow the instructions on the screen.

Alternatively, you can launch the tutorial by pressing HOME, then selecting [Settings] → [System Settings] → [Touchpad configurations] → [Start Tutorial].

For product protection and safety, Sony strongly recommends that the installation of your SONY BRAVIA KDL-65W955B television be performed by Sony dealers or licensed contractors. To prepare for wall mounting using the SU-WL450 Wall-Mount Bracket (not supplied), follow these steps:

1. Remove the screws from the rear of the TV. Be sure to store the removed screws in a safe place, away from children. Note: For Super Slim Mounting, there are certain screws you should not remove.

2. Before installing the Wall-Mount Bracket, attach the Wall-Mount Attachment (supplied with the TV) to the rear of the TV to make it parallel with the wall. This step is not needed for Super Slim mounting.

Be sure to fasten the Wall-Mount Attachment securely. If using an electric screwdriver, set the torque at approximately 1.5 N·m {15 kgf·cm}. Note that when using the Super Slim mounting style, some terminals on the rear of the TV cannot be used.

If the illumination LED on your SONY BRAVIA KDL-65W955B flashes red, it indicates a problem. First, try to reset the TV by disconnecting the mains lead from the TV for two minutes, then turn the TV back on.

If the problem persists, count the number of times the illumination LED flashes red (the interval time between flash sequences is three seconds). Then, press the power button on the TV to turn it off, disconnect the mains lead, and contact your dealer or a Sony service center with this information.

If your SONY BRAVIA KDL-65W955B has a dark screen and no sound, please try the following steps:

• Check the antenna (aerial) or cable connection to ensure it is secure.

• Make sure the TV is connected to the mains lead and press the power button on the TV or the remote control.

If you are having trouble tuning certain programmes on your SONY BRAVIA KDL-65W955B, check the following:

• Check the antenna (aerial) connection.

• If you are using a satellite connection, the satellite cable might be short-circuited or have connection problems. Check the cable connection, then turn the TV off with the Mains power On/Off switch, and turn it on again.

• The frequency you entered may be out of range. Consult the satellite broadcasting company for the correct frequency.

If the remote for your SONY BRAVIA KDL-65W955B is not functioning, try these solutions:

• Replace the batteries with new ones.

• Your TV may be in SYNC mode. Press the SYNC MENU button, select [TV Control], and then select [Home (Menu)] or [Options] to control the TV.

If you have forgotten the [Parental Lock] password for your SONY BRAVIA KDL-65W955B, you can enter 9999 for the PIN code. The PIN code 9999 is always accepted.

If your SONY BRAVIA KDL-65W955B experiences frozen audio or video, a blank screen, or becomes unresponsive to TV or remote buttons, perform a simple reset. Unplug the mains lead for two minutes, and then plug it back in.

If you do not wish to light up the illumination LED on your SONY BRAVIA KDL-65W955B, you can turn it off. Press the HOME button, then select [Settings] → [System Settings] → [General Set-up] → [Illumination LED] → [Off]. Alternatively, you can press the OPTIONS button, then select [Illumination LED] → [Off].

The following table provides details on the power consumption, dimensions, and mass for the SONY BRAVIA KDL-65W955B television.

*1 Energy consumption per year is based on the power consumption of the television operating 4 hours per day for 365 days. The actual energy consumption will depend on how the television is used.

*2 Specified standby power is reached after the TV finishes necessary internal processes.