SOLACE BREEZE (01) PDF Document

The SOLACE BREEZE cooling vest utilizes the physical cooling principle of water evaporation. It features a high water-absorbing and retaining material with a ventilation hole design, which delivers an instantaneous cooling effect. The vest cools through evaporation in the same way our bodies naturally cool. Therefore, in a climate of higher humidity (over 60%), the evaporative cooling will not be as efficient because the humidity decreases the ability for the water to evaporate from the vest.

Follow this three-step water injection process:

Step 1: Left Front Section Water Injection

From the back water inlet of the vest, slowly inject 500ml of water into the left front panel’s injection area. Immediately after pouring the 500ml, lay the vest flat and gently pat and smooth it from the inside outward with your palm to ensure even moisture penetration and absorption. This should take approximately 1 minute.

Step 2: Right Front Section Water Injection

Use the same method to inject 500ml of water into the right front section. Lay the vest flat and pat it evenly until the water is fully absorbed.

Step 3: Back Section Water Injection

Inject 1000ml of water into the back section of the vest and repeat the patting process for even absorption.

To enhance cooling effectiveness by 50%, fold the hydrated SOLACE BREEZE vest neatly and refrigerate it for 1-4 hours before use. For outdoor work or exercise, it is recommended to prioritize using ice water and refrigerating the vest before use.

After daily use, store the vest in the refrigerator. There is no need to refill it with water daily. Simply remove it from the refrigerator and wear it the next day. A refill is required after a maximum of 5 consecutive days of use.

Fit Adjustment:

Adjust the tightness via the elastic hem and cuffs to ensure the cooling layer adheres closely to the body. The side waist has a breathable mesh design that allows for heat dissipation during intense activities.

Scenario Adaptation:

For outdoor work/exercise, prioritize using ice water and refrigerate the vest before use.

For a daily commute, room-temperature water is sufficient for cooling needs.

Cleaning Method:

Hand wash the vest with water below 30°C and air dry by hanging.

Do not tumble dry.

Do not iron.

Do not dry clean.

Do not bleach.

Do not wring.

Long-term Storage:

Ensure the vest is completely dry after use before storing. Hang it in a dry area and avoid folding it to prevent compression of the water-retaining layer.

Minor water seepage may occur around the injection area during filling. Gently pat the surface until the water is fully absorbed to prevent leaks or dripping once it’s properly distributed.

When adding water, do not exceed 5000ml to avoid material damage from excessive water pressure.

The recommended refrigeration temperature is above -5°C.

DO NOT FREEZE.

If odors develop, soak the SOLACE BREEZE vest in diluted white vinegar for 10 minutes, then rinse it thoroughly with water.