MILWAUKEE REDLITHIUM L4 FFL (01) PDF DOCUMENT

Always read and understand all instructions before use to prevent electric shock, fire, and/or serious personal injury. Save these instructions for future reference.

1. BATTERY AND LIGHT USAGE:

• Use and charge only REDLITHIUM™ USB batteries in this USB rechargeable light. Other types of batteries may cause personal injury and damage.

• Before using the battery and light, read the operator’s manual and all labels on the battery and light.

2. ENVIRONMENT:

• Avoid dangerous environments. Do not charge the battery in rain, snow, damp or wet locations. Do not use the battery or charger in the presence of explosive atmospheres (gaseous fumes, dust or flammable materials) as sparks may be generated, possibly causing a fire.

• Charge in a well-ventilated area. Do not allow smoking or open flames near a charging battery as vented gases may explode.

3. ATTACHMENTS AND MAINTENANCE:

• Use only recommended attachments. Use of an attachment not recommended or sold by the battery charger or battery manufacturer may result in a risk of fire, electric shock or personal injury.

• To reduce the risk of electric shock, always unplug the charger before cleaning or maintenance.

• Maintain labels and nameplates. These carry important information. If unreadable or missing, contact a MILWAUKEE® service facility for a replacement.

4. HANDLING AND STORAGE:

• Store idle light out of reach of children. Warm lights can become hazardous in the hands of children.

• The clip is for mounting/securing the light only; do not use it for climbing or hanging other objects as it is not for fall protection.

• Close supervision is necessary when an appliance is used near children.

• DO NOT BURN OR INCINERATE: A battery may explode, causing personal injury or damage. Toxic fumes and materials are created when batteries are burned.

• DO NOT CRUSH, DROP, OR DAMAGE: Do not use a battery or charger that has received a sharp blow, been dropped, run over, or damaged in any way (e.g., pierced with a nail, hit with a hammer, stepped on).

• DO NOT DISASSEMBLE: Incorrect reassembly may result in the risk of electric shock, fire, or exposure to battery chemicals. If it is damaged, take it to a MILWAUKEE® service facility.

• AVOID SHORT CIRCUITS: A battery pack will short circuit if a metal object makes a connection between the positive and negative contacts. Do not place a battery pack near anything that may cause a short circuit, such as coins, keys or nails in your pocket. Do not allow fluids to flow into the battery pack. Corrosive or conductive fluids, such as seawater, certain industrial chemicals, and bleach or bleach-containing products, can cause a short circuit, which may lead to fire, personal injury, and product damage.

• HANDLE CHEMICALS SAFELY: Battery chemicals cause serious burns. Never allow contact with skin, eyes, or mouth. If a damaged battery leaks any fluid, use rubber or neoprene gloves to dispose of it. If skin is exposed to battery fluids, wash with soap and water, and rinse with vinegar. If eyes are exposed to battery fluids, immediately flush with water for 20 minutes and seek medical attention. Remove and dispose of contaminated clothing.

Cat. No.	L4 FFL
Rated power	5.7W
USB Input Volts	5V DC
USB Input Amps	0.1 – 2.1A DC
Output Volts	4V DC
Output Amps	2.1A DC
REDLITHIUM™ USB Batteries
Volts	4V DC
Operating Temperature
Battery and Charger	4°C to 40°C (40°F to 104°F)
Battery and Tool	-20°C to 60°C (-4°F to 140°F)
Ingress Protection	IP54

V	Volts
—	Direct Current
A	Amps
(Symbol of an eye with light rays)	Do not stare into light.
(Symbol of an open book)	Read Operator’s Manual
(Symbol of RCM mark)	Regulatory Compliance mark (RCM). This product meets applicable regulatory requirements.
III	Class III appliance

1. Twist the cap and remove.

2. Line up the battery with the compartment and fully insert the battery.

3. Replace the cap and twist to secure.

1. Plug your USB cable into a power source such as the supplied AC wall adaptor, computer or car port. Charge rates may vary depending on the power source’s maximum output.

2. Lift the rubber cover to expose the micro USB port. Insert the micro USB plug into the micro USB port.

3. The indicator light will display the charging status.

Red Solid: Charging, 0-79% charged

Green Flashing: Charging, 80-99% charged

Green Solid: 100% Charged

Red/Green Flashing: Damaged or Faulty Battery

If the light indicator flashes red and green, check that the battery is fully seated into the bay. Remove the battery and reinsert. If the light continues to flash red and green, the battery may be extremely hot or cold, or wet. Allow the battery to cool down, warm up, or dry out and then reinsert. If the problem persists, contact a MILWAUKEE® service facility.

To reduce the risk of injury, do not look directly into the light when the light is on.

Press the power button to cycle through High, Medium, Low, and Off. The indicator light will display the battery life.

When the light is turned on, the indicator light will display the battery life:

Red Flashing: 0-3% remaining

Red Solid: 3-10% remaining

Yellow Solid: 11-49% remaining

Green Solid: 50-100% remaining

Storage:

• Store in a cool, dry place. Do not store the battery where temperatures may exceed 50°C (120°F) such as in direct sunlight, a vehicle or metal building during the summer.

• Store batteries at room temperature away from moisture. Do not store in damp locations where corrosion of terminals may occur.

• MILWAUKEE® Li-Ion batteries maintain their charge during storage longer than other battery types. After about a year of storage, charge the battery as normal.

• As a general practice, it is best to unplug battery chargers and remove batteries when not in use. No battery damage will occur, however, if the charger and battery are left plugged in.

Maintenance:

• To reduce the risk of injury, always unplug the charger and remove the battery before performing any maintenance. The charger and battery have no internal serviceable parts. Never disassemble the battery or charger.

• The light source contained in this luminaire shall only be replaced by the manufacturer or his service agent or a similar qualified person.

• To reduce the risk of fire, personal injury, and product damage due to a short circuit, never immerse your light, battery pack or charger in fluid or allow a fluid to flow inside them.

Clean out dust and debris from charger vents and electrical contacts by blowing with compressed air. Use only mild soap and a damp cloth to clean the battery and charger, keeping away from all electrical contacts. Certain cleaning agents and solvents are harmful to plastics and other insulated parts. Some of these include gasoline, turpentine, lacquer thinner, paint thinner, chlorinated cleaning solvents, ammonia and household detergents containing ammonia. Never use flammable or combustible solvents around batteries, charger, or tools.

To reduce the risk of injury or explosion, never burn or incinerate a battery pack even if it is damaged, dead or completely discharged. When burned, toxic fumes and materials are created.

MILWAUKEE® Li-Ion batteries are more environmentally friendly than some other types of power tool batteries. Always dispose of your battery according to federal, state and local regulations. Contact a recycling agency in your area for recycling locations.

Even discharged batteries contain some energy. Before disposing, use electrical tape to cover the terminals to prevent the battery from shorting, which could cause a fire or explosion.