MILWAUKEE 48-32-6403 (01) PDF Document

To reduce the risk of electric shock, fire, and/or serious injury, follow these safety instructions:

•Read all safety warnings, instructions, illustrations, and specifications provided with this product, as well as those provided with the power tool, battery pack, and charger. Save all warnings and instructions for future reference.

•WARNING: Not insulated, do not use on or near live circuits.

•Dress properly. Do not wear loose clothing or jewelry. Keep your hair and clothing away from moving parts. Loose clothes, jewelry or long hair can be caught in moving parts.

•Always wear proper eye protection marked to comply with ANSI Z87.1.

•Do not let familiarity gained from frequent use of tools allow you to become complacent and ignore tool safety principles. A careless action can cause severe injury within a fraction of a second.

•Always use common sense and be cautious when using tools. It is not possible to anticipate every situation that could result in a dangerous outcome. Do not use this tool if you do not understand these operating instructions or you feel the work is beyond your capability; contact Milwaukee Tool or a trained professional for additional information or training.

The MILWAUKEE 48-32-6403 wire stripper should be used with a 1/4″ hex shank impact driver or drill/driver. Only use solid gauge wire; do not use for stranded wire. For best results, the wire should be straight, not bent or curved. Follow these steps for installation and use:

1. WARNING! Remove the battery from the power tool to avoid starting it.

2. Set the wire depth for your application.

3. Install the wire stripper bit according to the power tool instructions. Ensure the power tool is set in the forward direction.

4. Ensure the housing is fully screwed into the collar assembly.

5. Insert the battery pack into the drill/driver.

6. Pull the trigger to strip the wire.

If the wire is not stripped, remove the battery pack from the power tool and clear out the shavings in the wire stripper by removing the cover.

If the blade screw comes loose, use a 2.5 mm hex wrench to secure it back into position.

To remove the wire stripper bit, follow the instructions provided with your power tool for removing bits.

Use a clean cloth to wipe away any debris or shavings from the MILWAUKEE 48-32-6403. Store it in a dry and clean environment.

The main components of the MILWAUKEE 48-32-6403 are:

1. Housing

2. Blade

3. Wire gauge

4. Collar

5. Adjustable shank

6. Wire depth