MILWAUKEE 48-32-6406 (01) PDF Document

To reduce the risk of electric shock, fire and/or serious injury, read all safety warnings, instructions, illustrations, and specifications provided with this product, as well as those provided with the power tool, battery pack, and charger. Save all warnings and instructions for future reference. The term “power tool” in the warnings refers to your mains-operated (corded) power tool or battery-operated (cordless) power tool.

WARNING: Not insulated, do not use on or near live circuits.

•Dress properly. Do not wear loose clothing or jewelry. Keep your hair and clothing away from moving parts. Loose clothes, jewelry or long hair can be caught in moving parts.

•Always wear proper eye protection marked to comply with ANSI Z87.1.

•Do not let familiarity gained from frequent use of tools allow you to become complacent and ignore tool safety principles. A careless action can cause severe injury within a fraction of a second.

•Always use common sense and be cautious when using tools. It is not possible to anticipate every situation that could result in a dangerous outcome. Do not use this tool if you do not understand these operating instructions or you feel the work is beyond your capability; contact Milwaukee Tool or a trained professional for additional information or training.

Goggles Symbol: Always wear proper eye protection marked to comply with ANSI Z87.1

Lightning Bolt with Slash Symbol: Not insulated, do not use on or near live circuits

Curved Arrow Symbol: Direction of rotation

1. Housing

2. Blade

3. Wire gauge

4. Collar

5. Adjustable shank

6. Wire depth

Use the wire stripper with a 1/4″ hex shank impact driver or drill/driver. Only use solid gauge wire. Do not use for stranded wire. For best results, the wire should be straight, not bent/curved.

1. WARNING! Remove battery to avoid starting the tool.

2. Set the wire depth for application.

3. Install the wire stripper bit according to the power tool instructions. Ensure power tool is set in forward direction.

4. Ensure housing is fully screwed into the collar assembly.

5. Insert the battery pack in the drill/driver.

6. Pull the trigger to strip the wire.

If the wire is not stripped, remove the battery pack and clear out the shavings in the wire stripper by removing the cover.

If the blade screw comes loose, use 2.5 mm hex wrench to secure into position.

Use a clean cloth to wipe away any debris/shavings. Store in a dry and clean environment.