Free English LINX EDEN (01) PDF document. Download the PDF, use the online viewer, or browse the FAQs for easy troubleshooting.
CLICK HERE TO DOWNLOAD LINX EDEN (01) PDF DOCUMENT
If this is not the document you want for this product, click here to see if we have any other documents for this product.
How to use the PDF below:
* Touchscreen: Swipe up/down with-in the PDF to scroll and pinch or spread with two fingers to zoom.
* Mouse: While your mouse is hovering over the PDF, use the mouse wheel to scroll and click on the – / + buttons at the bottom of the PDF to zoom.
What are the components of the LINX EDEN?
The LINX EDEN includes the following components:
1 LINX EDEN
1 Magnetic Cap
1 USB Charger
1 Cleaning Brush
How do you charge the LINX EDEN?
Plug the LINX EDEN into a USB port or power adapter to charge. The LED light will glow red when charging and turn off when fully charged.
How do you turn on/off the LINX EDEN?
Press the power button 5 times rapidly to turn the LINX EDEN on or off.
How do you load the LINX EDEN?
To load the LINX EDEN, remove the magnetic cap and load your material into the quartz chamber. Gently place the cap back on the LINX EDEN.
How do you use the LINX EDEN?
Press the power button 5 times rapidly to turn on the LINX EDEN. The LINX EDEN will glow to indicate it is on. Press the power button 3 times rapidly to cycle through the temperature settings. The LINX EDEN will indicate the temperature setting by glowing a specific color: blue (low), green (medium), red (medium-high), or yellow (high). Press and hold the power button to heat the chamber. Once the desired temperature is reached, the light will turn solid. Inhale slowly and enjoy. If the chamber reaches maximum temperature, the light will flash. Release the power button to stop heating the chamber. Repeat steps as needed.
What do the LINX EDEN LED lights indicate?
| LED Color | Indication |
|---|---|
| Red (while charging) | Charging |
| No light (while charging) | Fully Charged |
| Blue | Temperature setting: Low |
| Green | Temperature setting: Medium |
| Red | Temperature setting: Medium-High |
| Yellow | Temperature setting: High |
| Flashing light | Chamber reached maximum temperature |
How do you clean the LINX EDEN?
To clean the LINX EDEN, remove the magnetic cap and ensure the device is cool. Gently brush the quartz chamber with the included cleaning brush. For a deeper clean, moisten a cotton swab with isopropyl alcohol and wipe the chamber. Let it dry completely before use.
How do you replace the LINX EDEN mouthpiece?
To replace the LINX EDEN mouthpiece, simply pull the old mouthpiece from the magnetic cap. Push the new mouthpiece in until it is secure.
CLICK HERE TO DOWNLOAD LINX EDEN (01) PDF DOCUMENT