ASPIRE SPEEDER 200W (01) PDF Document

Ensure the correct positive and negative installation of the ASPIRE SPEEDER 200W battery.

To turn on the ASPIRE SPEEDER 200W, press the fire button 5 times in quick succession.

To turn off the ASPIRE SPEEDER 200W, press the fire button 5 times in quick succession.

To lock or unlock the adjustment buttons on the ASPIRE SPEEDER 200W, press the fire button 3 times.

To switch between vaping modes on the ASPIRE SPEEDER 200W, press the fire button and “+” button simultaneously.

To access the stealth function on the ASPIRE SPEEDER 200W, press the fire button and “-” button simultaneously.

To rotate the screen display on the ASPIRE SPEEDER 200W, press the “+” and “-” buttons simultaneously.

The ASPIRE SPEEDER 200W offers the following output modes:

WATTAGE (VW): In this mode, you can adjust the wattage from 1 to 200W.

VOLTAGE (VV): In this mode, you can adjust the voltage from 0.1 to 8.4V.

BYPASS: This mode delivers direct output voltage.

TC (Ti/Ni/SS/M1/M2/M3): These are temperature control modes for Titanium, Nickel, Stainless Steel, and three customizable TCR settings.

CPS (C1/C2/C3): These are customizable power setting modes that allow you to set specific power curves.

To switch between VW and VV modes on the ASPIRE SPEEDER 200W, enter the mode setting interface by simultaneously pressing the fire button and “+” button, then select either VW or VV mode.

To use BYPASS mode on the ASPIRE SPEEDER 200W, enter the mode setting interface by simultaneously pressing the fire button and “+” button, then select BYPASS mode. In BYPASS mode, the device will deliver direct output voltage.

To use TC mode on the ASPIRE SPEEDER 200W, enter the mode setting interface by simultaneously pressing the fire button and “+” button, then select TC mode. You can then choose between Ti, Ni, SS, M1, M2, or M3. The temperature range is 100-315°C / 200-600°F.

In TC mode on the ASPIRE SPEEDER 200W, you can set TCR values for M1, M2, and M3. Navigate to the TCR M1, M2, or M3 settings within the TC mode. Press the “+” or “-” button to adjust the TCR value. Press the fire button to confirm the setting. The table below provides recommended TCR values for common coil materials:

To use CPS mode on the ASPIRE SPEEDER 200W, enter the mode setting interface by simultaneously pressing the fire button and “+” button, then select CPS mode. You can then choose between C1, C2, or C3. In this mode, you can customize the power curve for up to 10 seconds. Press the fire button to save your settings.

The ASPIRE SPEEDER 200W can be charged via the Micro-USB port. When the device is charging, the screen will display two charging battery icons. When the charge reaches 4.2V, the ASPIRE SPEEDER 200W will automatically stop charging. The ASPIRE SPEEDER 200W also supports firmware upgrades through the Micro-USB port.

Please observe the following safety precautions when using the ASPIRE SPEEDER 200W:

Only use quality high-rate 18650 batteries. The ASPIRE SPEEDER 200W requires dual 18650 batteries with a minimum discharge current of 25A. Only use batteries that match these specifications. Otherwise, it may result in injury.

Do not expose the device to direct sunlight, high temperatures, or moisture.

Do not attempt to disassemble the ASPIRE SPEEDER 200W.

Keep the ASPIRE SPEEDER 200W away from children.

This product is not recommended for use by young people, non-smokers, pregnant or breast-feeding women, or persons who are allergic/sensitive to nicotine.