LELO ORA 3 (01) PDF Document

Before first use, charge your LELO ORA 3 for 2 hours.

Your device has been locked for transportation. To unlock, simply connect the charger or press and hold the + and – buttons together for 3 seconds until the light turns on.

Press the + button to turn the device on; press it again to increase the vibration strength.

Press the ( ) button to switch between the 12 vibration patterns.

Press the – button to reduce vibration strength.

Press and hold the ( ) button to turn the device off.

Insert the DC plug into the DC port at the base of your LELO ORA 3.

Insert the mains plug into a wall socket. The LED on the interface of your LELO ORA 3 will pulse to indicate it is charging. When it is fully charged (after approximately 1.5 hours), the LED will emit a steady glow.

When the battery is running low, the LED on your LELO ORA 3 will emit a blinking white light.

Only use original chargers provided by LELO with your device.

For an even more pleasurable sensation, apply a liberal amount of LELO Personal Moisturizer to your body and to the LELO ORA 3 before and during use.

Using the LELO ORA 3 with hand creams or silicone-based lubricants may make the silicone permanently tacky.

The LELO ORA 3 is fully waterproof, making cleaning simple. Rinse and spray with LELO Toy Cleaner, then rinse again and allow to dry.

Always clean your device thoroughly before and after each use. You can wash the silicone with warm water and antibacterial soap, rinse with clean hot water and pat dry with a lint-free cloth or towel. Never use cleansers containing alcohol, petrol or acetone.

Avoid leaving your LELO ORA 3 in direct sunlight and NEVER expose it to extreme heat. Store your device in a dust-free place and keep it away from products of other materials.

If the LED does not pulse when the charger is connected, the battery may be drained and will require several minutes to acknowledge that it is being charged.

Additionally, ensure the charger is properly connected by checking both the wall and DC sockets.

If the device does not activate, the battery may be empty. You should recharge your LELO ORA 3.

Alternatively, the interface of your LELO ORA 3 may be locked. Hold down the + and – buttons for 5 seconds to unlock it.