LELO GIGI 2 (03) PDF Document

The LELO GIGI 2 is locked for transportation during shipping. To unlock the device, simply connect it to the charger. You can also unlock the interface of the LELO GIGI 2 by holding down the + and – buttons simultaneously for 5 seconds.

Please consult your healthcare provider with any questions or concerns you may have regarding your condition before use.

The LELO GIGI 2 can be used by adults only. Keep the device out of reach of children.

People with reduced physical, sensory, or mental capabilities or lack of experience and knowledge should use the device only if they have been given supervision or instruction concerning the use of the device in a safe way and understand the hazards involved.

Only use the product for the intended purpose. Sharing sex toys with other people may transmit sexual diseases. Do not share your LELO GIGI 2 with people other than your partner.

Use protective measures with your partner if necessary.

Do not use the LELO GIGI 2 if you detect any cracks or signs of degradation on the covering material.

To prevent stains, do not keep your product on absorbent surfaces. If the device operates abnormally, turn it off immediately.

Do not use the LELO GIGI 2 if one or more components are damaged.

The appliance must only be supplied at SELV (Safety Extra Low Voltage).

Step 1. Before the first use, charge your LELO GIGI 2 for 2 hours.

Step 2. Press and hold the + button to turn the device on.

Step 3. Press the up arrow and the down arrow buttons to switch between the 8 available vibration modes.

Step 4. Use the + and – buttons to increase or decrease the vibration intensity.

Step 5. Press and hold the – button to turn the LELO GIGI 2 off.

The LELO GIGI 2 features a G-spot stimulator and is designed for placement on the clitoris, outer labia, inner labia, and vagina.

For an even more pleasurable sensation, you can apply a liberal amount of LELO Personal Moisturizer to your body and to the LELO GIGI 2 before and during use.

To charge the device, insert the DC plug into the DC port at the base of your LELO GIGI 2. Insert the mains plug into a USB Port. Only use original chargers provided by LELO.

While charging, the LED on the interface of the LELO GIGI 2 will pulse. When it is fully charged, the LED will emit a steady glow. When the battery is running low, the LED will emit a blinking white light.

The LELO GIGI 2 is fully waterproof, making cleaning simple. Always clean the device thoroughly before and after each use. You can wash the silicone with warm water and antibacterial soap, rinse with clean hot water, and pat dry with a lint-free cloth or towel.

Alternatively, you can rinse and spray the device with LELO Toy Cleaner, then rinse again and allow it to dry.

Avoid using hand creams or silicone-based lubricants as they may make the silicone permanently tacky. Never use cleansers containing alcohol, petrol, or acetone.

Avoid leaving the LELO GIGI 2 in direct sunlight and never expose it to extreme heat. Store the device in a dust-free place and keep it away from products made of other materials.

If the LED does not pulse when the charger is connected, the battery may be completely drained and require several minutes to acknowledge it is being charged. Also, check that the charger is properly connected to the wall and DC sockets.

If the LELO GIGI 2 does not activate when the center button is pressed, the battery may be empty and requires recharging. If the battery is charged but the device still does not activate, the interface might be locked. Hold down the + and – buttons at the same time for 5 seconds to unlock it.

The specifications for the LELO GIGI 2 are as follows: