LASER HPS-BT24 (01) PDF DOCUMENT

The box for the LASER HPS-BT24 includes the following items:

• Headphone

• USB-A to USB-C charging cable

• User manual

The functions are as follows:

1. microSD card slot

2. Volume +/Next track

3. Volume -/Previous track

4. LED indicator

5. 3.5mm audio jack

6. Microphone

7. USB-C charging port

8. Mode (BT/Micro SD)

9. Power/Call

The Status Indicator LED lights indicate the following:

• Flashing red & blue: In Bluetooth pairing mode

• Flashes blue every 10s: Connected via Bluetooth

• Constant red: Charging battery

• Constant blue: Battery fully charged

You should charge the headphones fully before their first use. Use the included cable to connect the headphones to a 5V USB-A wall charger, computer, or power bank.

To turn on, press and hold the Power/Call button for 2 seconds. The headphones will provide a prompt when they are on.

To turn off, press and hold the Power/Call button for 5 seconds.

• Press the Play/Call button to play/pause audio.

• Press the Volume +/- buttons to increase/decrease volume.

• Press and hold the Volume +/- buttons to skip tracks forward/back.

• Answer/end calls by pressing the Power/Call button.

• Double press the Power/Call button to redial the last number.

• Hold the Power/Call button for 2 seconds to reject an incoming call.

• Press the Power/Call button 3 times to activate your device’s voice assistant.

1. Enable Bluetooth mode on your smartphone or device.

2. Select HPS-BT24 from the list of available devices.

3. If the headphones are disconnected for 5 minutes, they will turn off automatically.

Note: If HPS-BT24 does not appear on the connecting device, retry from step 1.

The headphones can be paired with two devices, but can only play music from 1 paired device at a time. If you try to pair a third device, it will disconnect one of the other devices.

1. Insert a microSD card into the headphones’ slot for playing music files.

2. With the microSD card inserted, the headphones will automatically enter Micro SD play mode.

3. Press the Mode button to switch between Micro SD card and Bluetooth modes.

1. Connect a 3.5mm audio cable (not included) to the headphones and the audio source device.

2. The headphones will work in passive auxiliary mode without needing Bluetooth.

3. If the headphones are on in Bluetooth or Micro SD mode, inserting the audio cable will turn them off to save battery.

• Excessive volume can harm your hearing.

• Be cautious when using the device while walking, driving, or cycling to prevent accidents.

• Keep headphones away from moisture, dust, or extreme heat.

• Clean surfaces with a soft, dry cloth only.

• Do not disassemble the headphones or battery pack.

• Avoid storage below 0°C or above 45°C.

• Follow local laws for proper disposal and battery recycling; avoid putting it in kerbside bins.

The battery could be dead. Charge the headphones using a compatible 5V USB power source.

• Check if the volume is low or muted. Unmute or increase the volume.

• Ensure a Bluetooth device is connected.

• Keep the headphones near the device (within 10m range) during connection.

• Ensure the headphones are in Bluetooth mode. Turn them off and on again to switch modes.

• If the headphone’s Bluetooth name is not found, refresh or search again. Wait up to 1 minute for the device to appear.

• If the headphones are paired to another device, disconnect them before connecting to your device.

• Bluetooth version: 5.3

• Bluetooth range: 10m

• Battery capacity: 300mAh

• Charging case power input: 5V