SAMSUNG COLOR LASER MFP CLX-626XND (01) PDF MANUAL

The recommended environmental and space conditions are:

Temperature: 10°C to 30°C (50°F to 86°F).

Clearance:

– At least 300 mm in front of the printer (likely for tray access and operation).

– At least 100 mm on the sides of the printer.

– At least 100 mm clearance (likely for the top or rear, ensure adequate ventilation and access).

The printer itself has a depth of approximately 482.6 mm.

Follow these steps to install the toner cartridge:

1. Open the front cover of the printer.

2. Pull out the toner cartridge holder.

3. Unpack the new toner cartridge.

4. Gently shake the new toner cartridge 5 to 6 times to distribute the toner evenly.

5. Remove the protective cover from the new toner cartridge.

6. Align the new toner cartridge with its corresponding slot in the holder and insert it firmly until it clicks into place.

7. Push the toner cartridge holder back into the printer until it is fully seated.

8. Close the front cover of the printer.

Follow these steps to load paper:

1. Pull the paper tray completely out of the printer.

2. Adjust the paper guides:

– Press the guide lock (if present) and pull the tray out to its full extent, especially if loading Legal (LGL) size paper.

– Slide the paper length guide and paper width guides to match the size of the paper you are loading.

3. Prepare the paper: Flex or fan the edge of the paper stack to separate the pages before loading. This helps prevent paper jams.

4. Load paper into the tray:

– Place the paper with the print side facing up.

– Do not overfill the tray. Ensure the paper stack is below the maximum paper capacity mark indicated on the inside of the tray.

5. Carefully insert the paper tray back into the printer until it clicks firmly into place.

Recommended paper types mentioned:

– Letter: Xerox Business Multipurpose 4200 or 20lb, 92 brightness.

– A4: Xerox Premier or 80g/m², 92 brightness.

1. Connect one end of the power cable to the power input port on the back of the printer.

2. Connect the other end of the power cable to a working electrical outlet.

3. Press the Power button on the printer to turn it on.

If your printer model supports faxing and you intend to use this feature:

1. Locate the “LINE” port on the back of your printer.

2. Connect one end of a telephone line cord to this “LINE” port.

3. Connect the other end of the telephone line cord to your telephone wall jack.

To install the printer software, go to the website: `www.samsung.com/printersetup`.

Follow the instructions on the website to download and install the necessary software and drivers for your printer.

Note: The guide indicates that the primary software installation shown is for Windows operating systems (“Windows only”).

If you have a wireless model, you can set up the wireless connection easily using an app:

1. Download the “Samsung Mobile Print” app. The guide shows it available on Google Play for Android devices.

2. Once the app is installed, open it and look for network or printer setup options.

3. Alternatively, your printer’s control panel may have a “Wi-Fi Setup” option under “Setting”. Use this to configure the wireless network.

For detailed information about the wireless setup, please refer to the User Guide for your specific model.

For more detailed information, including comprehensive operating instructions and important safety guidelines, please refer to the User’s Guide for your printer.

You can usually find the User’s Guide and other support materials on the official Samsung website: `www.samsung.com`.

It is important to read the safety guidelines in the User’s Guide before operating the printer.