LARQ BOTTLE FILTERED (01) PDF Document

The LARQ BOTTLE FILTERED works best if used regularly. For pure-tasting water, the filters should be replaced every 2 months. Before washing your bottle, remove the filter first, then hand wash the bottle with mild soap and warm water.

Step 1. Remove the filter from the filter pod and dispose of the outer packaging.

Step 2. Rinse the filter under running water for 10 seconds to ensure it’s soaked.

Step 3. Push the straw into the cap base until it’s secure.

Step 4. Install the filter with the tip facing down, and screw the pod cap on securely.

Step 5. Fill the bottle with cold or room temperature tap water and screw on the cap.

Step 6. Push down on the designated area on the cap to flip it open and start sipping.

Please adhere to the following safety guidelines for your LARQ BOTTLE FILTERED:

• Do not use with hot water.

• Do not use to filter anything other than water. Do not use with carbonated water.

• Do not place the filter in the dishwasher.

• Do not place the bottle in the microwave or freezer.

• The filter is intended to be used with potable (municipal tap) water only. Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before and after filtration.

• Do not cut open or perforate the filter.

• Do not wash the filter at any time.