LA PAVONI EUROPICCOLA (01) PDF Document

To start your LA PAVONI EUROPICCOLA for the first time, follow these steps:

Step 1. Unscrew the boiler cap (3) by turning it anticlockwise.

Step 2. Prepare a solution of water and two teaspoons of bicarbonate of soda in a container. Wait for it to dissolve completely, then pour the solution into the boiler (9). Alternatively, you can use a solution of water with one tablespoon of white vinegar.

Step 3. Make sure the lever (1) is down; if necessary, pull it down fully.

Step 4. Screw the boiler cap (3) on by turning it clockwise and ensure that the cap and the steam knob (4) are properly closed.

Step 5. Place the filter holder (10) into the group head (11) and secure it by moving it from right to left.

Step 6. Insert the power plug into a suitable electric socket.

Step 7. Place the switch (6) to ON and wait for the machine to reach the required pressure (approximately 5 minutes).

Step 8. Place a container under the group head (11) and slowly lift the lever (1) until it is fully raised. Hold it in this position to discharge all the water contained in the boiler.

Step 9. Switch the machine off and remove the plug from the power outlet. Turn the steam knob (4) anticlockwise and wait until all the steam has been discharged from the steam pipe (12).

Step 10. Fill the boiler again with clean water and rinse the inside of the machine to eliminate any residues left by the solution.

To start your LA PAVONI EUROPICCOLA, first fill the boiler (9) with enough water for the amount of coffee you wish to make. The water level should not exceed the top of the level glass (5) and should not fall below the lower part.

For EUROPICCOLA / STRADIVARI Models:

Step 1. Press the switch (6). It will light up, and the indicator light (7) will switch on to indicate the heating element is activated.

Step 2. Wait for the light (7) to turn off. Then, slowly open the steam knob (4) anticlockwise to discharge the “false pressure” from air left in the boiler. Close it by turning it clockwise.

Step 3. The indicator light will come back on; wait for it to switch off again.

Step 4. The machine has now reached the correct pressure and is ready to dispense coffee and steam.

For PROFESSIONAL / STRADIVARI PROFESSIONAL / EXPO Models:

Step 1. Press the switch (6). It will light up, and the indicator light (7) will switch on to indicate the heating element is activated.

Step 2. When the pointer of the pressure gauge (13) reaches the green zone, slowly open the steam knob (4) anticlockwise to discharge the “false pressure”. Close it by turning it clockwise and wait for the pointer to move back into the green zone.

Step 3. The machine has now reached the correct pressure and is ready for use.

Follow these steps to dispense coffee from your LA PAVONI EUROPICCOLA:

Step 1. Select the correct filter basket (small 16a for 1 cup, large 16 for 2 cups) and place it into the filter holder (10). Insert the filter holder and wait for the machine to reach the correct temperature.

Step 2. Once at the right temperature, remove the filter holder (10) and fill the filter basket with ground coffee using the measuring scoop (15). Use one scoop for each cup of coffee.

Step 3. Press the coffee using the tamper (14) and clean any residue from the edge of the filter.

Step 4. Hold the machine steady by the handgrip of the lever (1) and insert the filter holder (10) into the group head (11). Secure it by turning it slightly from right to left.

Step 5. Position the cup(s) under the spouts of the filter holder.

Step 6. Move the lever (1) upwards while holding the handle of the filter holder with your left hand to keep the machine steady. Hold it in this position for a few seconds.

Step 7. Then lower the lever as far as it will go to dispense coffee. Repeat this procedure according to the amount of coffee required.

Step 8. After preparing the coffee, leave the lever (1) in the down (rest) position and switch the machine off.

Note: After dispensing 3-4 consecutive coffees, it is recommended to wait a few minutes to allow the group head to return to the right temperature to avoid dispensing burnt coffee. Before dispensing, always make sure the water level in the boiler is not below the minimum.

Once the water in the boiler has run out, refill it as follows:

Step 1. Place the switch (6) in the off position before unscrewing the cap (3).

Step 2. Slowly turn the steam knob (4) anticlockwise and wait for all the steam in the boiler to be discharged from the specific pipe (12).

Step 3. Remove the filter holder (10) and slowly lift the lever (1). Keep the lever up to allow the steam and water in the boiler to discharge through the group head. Use a container to collect the hot steam and water.

Step 4. When the steam and water stop discharging, slowly unscrew the boiler cap (3). Then fill the boiler.

Step 5. Before screwing the boiler cap (3) back on, move the lever (1) to the rest position and close the steam knob (4) by turning it clockwise.

Caution: Do not open the boiler cap (3) when the machine is in operation or still under pressure to avoid possible burns. Regularly check the amount of water in the boiler through the level glass (5). Lack of water when the machine is in operation may cause the heating element to burn out.

To prepare a cappuccino with the steam pipe, follow these steps:

Step 1. Half fill a tall narrow container with the milk to be prepared.

Step 2. Immerse the steam pipe (12) until it touches the bottom of the container and slowly turn the steam knob (4) anticlockwise.

Step 3. Move the container slowly up and down for a few seconds until you obtain a froth.

Step 4. To make a cappuccino, add the hot frothed milk to the coffee that is already in the cup.

Installing the Automatic Cappuccino Maker:

Step 1. Ensure the machine is switched off and the steam knob (4) is closed.

Step 2. Using the provided tool (F), turn the headless screw on the tap body clockwise to release the steam nozzle.

Step 3. Turn the steam pipe (12) clockwise until it stops, then remove it from its seat by pulling it towards the right.

Step 4. Insert the Automatic Cappuccino maker onto the steam supply nozzle (18), pushing it upwards until the nozzle rests against the fitting. Then tighten the locking ring by turning it clockwise.

Step 5. Insert the Automatic Cappuccino maker (17) into its seat by pushing it towards the left. Turn it anticlockwise until it stops.

Step 6. Using the tool (F), turn the headless screw on the tap body anticlockwise to lock the automatic cappuccino maker in position. Ensure the headless screw is always in the locked position during operation.

Preparing a Cappuccino:

Step 1. After the machine has reached the required pressure, insert the suction tube (20) into the milk container next to the machine.

Step 2. Place the cup with previously prepared coffee under the nozzle of the Automatic Cappuccino maker and open the steam knob (4) by turning it anticlockwise. This will dispense hot milk with abundant froth.

Step 3. To stop dispensing, close the steam knob (4) by turning it clockwise. You can regulate the froth by adjusting the pin (C) of the maker.

For Tea/Camomile Tea:

Step 1. Place the required amount of water into a container.

Step 2. Immerse the steam pipe (12) into the liquid and slowly turn the steam knob (4) anticlockwise.

Step 3. Open the steam knob completely to dispense a large quantity of steam, which will bring the liquid to a boil.

Step 4. Add the contents of the sachet of the drink you wish to prepare.

For Hot Chocolate:

Step 1. Place the contents of the sachet into a container and slowly add a cup of milk a little at a time while mixing carefully.

Step 2. Immerse the steam pipe (12) until it touches the bottom of the container, slowly turn the steam knob (4) anticlockwise, and bring the drink to a boil.

Step 3. Allow the drink to boil longer if you wish to make it denser.

Clean the outside of the machine, the drip tray (8), and the drain well on the base using a damp cloth and then dry it. Do not use alcohol, solvents, abrasives, or detergents, to avoid damaging the treated surfaces.

Filter Holder: Regularly clean the filter holder (10), the filter (16), and the shower screen located in the group head (11) with warm water and a neutral detergent to prevent scale and remove coffee deposits. Warning: To prevent damaging the machine, do not use the blind filter for cleaning the group head.

Steam Pipe: To avoid altering the taste of drinks and to prevent the holes from becoming clogged, clean the steam pipe thoroughly with a damp cloth after every use.

Remove any milk residues each time the Automatic Cappuccino maker is used.

Quick Clean:

Step 1. Place a full glass of water next to the machine and immerse the Suction tube.

Step 2. Proceed as if you were preparing a normal cappuccino, allowing the dirty water to drain into a suitable container.

Thorough Clean:

Step 1. Turn the threaded locking ring (A) anticlockwise until the steam nozzle is released.

Step 2. Remove the cover (D), the pin (C), and the pipe (B) and wash them thoroughly under warm running water to eliminate residues or hardened lumps of milk.

Step 3. Replace the components in the reverse order.

Your LA PAVONI EUROPICCOLA must not be disposed of together with household waste. All waste electrical and electronic appliances must be disposed of separately from domestic waste and taken to authorized waste disposal facilities. Disposing of the used appliance correctly will help to safeguard the environment and human health.

If your LA PAVONI EUROPICCOLA does not work and the ON/OFF switch light is off, check the following:

Cause 1: No power.
Solution 1: Switch the power on.

Cause 2: The machine is not plugged in correctly.
Solution 2: Insert the power plug correctly into the power socket.

Cause 3: The power cable is damaged.
Solution 3: Contact a SERVICE CENTRE for replacement.

If the light on the ON/OFF switch is lit but the water does not heat up, here are the possible causes and solutions:

Cause 1: The safety thermostat needs to be reset.
Solution 1: Remove the base mat cap and press the red button to reset the thermostat.

Cause 2: The heating element is broken or burnt out.
Solution 2: Contact a SERVICE CENTRE.

If no coffee is dispensed, check the following potential issues:

Cause 1: There is no water in the boiler.
Solution 1: Put water into the boiler.

Cause 2: The coffee is too finely ground.
Solution 2: Replace with a coarser coffee blend.

Cause 3: There is too much coffee.
Solution 3: Reduce the amount of coffee in the filter basket.

Cause 4: The coffee has been compacted too much.
Solution 4: Tamp the coffee less.

If coffee is dispensed too quickly, consider these causes and solutions:

Cause 1: The coffee is too coarsely ground.
Solution 1: The coffee should be ground more finely.

Cause 2: There is not enough coffee.
Solution 2: Increase the amount of coffee.

Cause 3: The coffee has not been compacted enough.
Solution 3: Tamp the coffee more.

Cause 4: The coffee is stale or unsuitable.
Solution 4: Replace the coffee.

If coffee dispenses in drops, it may be due to the following:

Cause 1: The coffee is too finely ground.
Solution 1: The coffee should be ground more coarsely.

Cause 2: There is too much coffee.
Solution 2: Reduce the amount of coffee.

Cause 3: The coffee has been compacted too much.
Solution 3: Tamp the coffee less.

If coffee leaks between the boiler unit and the filter holder, check these possible reasons:

Cause 1: The filter holder is not inserted correctly.
Solution 1: Insert it properly.

Cause 2: There is too much coffee in the filter basket.
Solution 2: Reduce the amount of coffee.

Cause 3: The edge of the filter holder has not been cleaned.
Solution 3: Remove coffee residues from the edge of the filter holder.

Cause 4: The gasket of the boiler unit is worn.
Solution 4: Contact a SERVICE CENTRE.

If no froth forms on the coffee, the reasons could be:

Cause 1: The coffee blend is not suitable for this type of machine.
Solution 1: Replace the coffee.

Cause 2: The grinding is unsuitable.
Solution 2: Adjust the coffee grind.

Cause 3: There is not enough coffee.
Solution 3: Increase the amount of coffee.

If your coffee is too cold, check these possible causes and their solutions:

Cause 1: The machine had not reached the correct temperature.
Solution 1: Follow the instructions given in section 4.4 of the manual.

Cause 2: The filter holder had not been pre-heated.
Solution 2: The filter holder should be heated at the same time as the water.

Cause 3: Scale on the heating element.
Solution 3: Descale the machine.

Cause 4: Heating element partially burnt out.
Solution 4: Contact a SERVICE CENTRE.

Cause 5: The pressure switch is not working within the required range.
Solution 5: Contact a SERVICE CENTRE.

If the coffee is too hot, the likely cause is that the pressure switch is not working within the required range. The solution is to contact a SERVICE CENTRE.

If the safety valve whistles and steam is exiting from the valve or condensation basin, check these potential issues:

Cause 1: The spring that regulates the safety valve is blocked.
Solution 1: Contact a SERVICE CENTRE.

Cause 2: The pressure switch is not working within the required range.
Solution 2: Contact a SERVICE CENTRE.

If the machine does not dispense steam, consider these causes and solutions:

Cause 1: The machine has not reached the correct pressure.
Solution 1: See the instructions given in section 4.4 of the manual.

Cause 2: The holes at the end of the steam pipe are clogged.
Solution 2: Clean the holes with a needle.

Cause 3: There is no water in the boiler.
Solution 3: Put water into the boiler.

Cause 4: The steam pipe has not been inserted properly.
Solution 4: Insert the steam pipe properly.

Cause 5: There is scale on the heating element.
Solution 5: Descale the machine.

If your LA PAVONI EUROPICCOLA is noisy or vibrating, check the following:

Cause 1: The coils of the heating element are too close.
Solution 1: Contact a SERVICE CENTRE.

Cause 2: There is scale on the heating element.
Solution 2: Descale the machine.