ELECTROLUX LFG719W (01) PDF Document

Before installing and using the ELECTROLUX LFG719W, carefully read the supplied instructions. The manufacturer is not responsible for any injuries or damage resulting from incorrect installation or usage. Always keep the instructions in a safe and accessible location for future reference.

Children and vulnerable people safety:

• This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning the use of the appliance in a safe way and understand the hazards involved. Children of less than 8 years of age and persons with very extensive and complex disabilities shall be kept away from the appliance unless continuously supervised.

• Children should be supervised to ensure that they do not play with the appliance.

• Keep all packaging away from children and dispose of it appropriately.

• Keep children and pets away from the appliance when it operates.

• Children shall not carry out cleaning and user maintenance of the appliance without supervision.

General Safety:

• This appliance is intended for domestic use above hobs, cookers and similar cooking devices.

• Before carrying out any maintenance, disconnect the appliance from the power supply.

• CAUTION: Accessible parts may become hot during use with cooking appliances.

• Use only the fixing screws supplied with the appliance if not supplied; use the screws recommended in the installation instructions.

• Do not use adhesives to fix the appliance.

• The minimum distance between the hob surface on which the pans stand and the lower part of the appliance shall be at least 65 cm, unless otherwise specified in the installation instructions for the appliance or hob.

• The discharge of air must comply with local authorities regulations.

• Ensure good air ventilation in the room where the appliance is installed to avoid the backflow of gases into the room from appliances burning gas or other fuels, including open fires.

• Make sure that the ventilation openings are not blocked and the air collected by the appliance is not conveyed into a duct used to exhaust smoke and steam from other appliances (central heating systems, thermosiphons, water-heaters, etc.).

• When the appliance operates with other appliances the maximum vacuum generated in the room should not exceed 0.04 mbar.

• If the supply cord is damaged, it must be replaced by the manufacturer, its Authorised Service Centre or similarly qualified persons to avoid an electrical hazard.

• Do not flambé under the appliance.

• Do not use to exhaust hazardous or explosive materials and vapours.

• Clean the appliance regularly with a soft cloth to prevent the deterioration of the surface material.

• Do not use a steam cleaner, water spray, harsh abrasive cleaners or sharp metal scrapers to clean the surface of the appliance. Use only neutral detergents.

• Clean grease filters regularly (at least every 2 months) and remove grease deposits from the appliance to prevent the risk of fire.

• Use a cloth to clean the interior of the appliance.

It is recommended to leave the hood operating for approximately 15 minutes after cooking.

To operate the hood:

1. Press the first speed button to switch on the appliance.

2. If needed, press the light button to illuminate the cooking surface.

3. If needed, change the speed by pressing the desired button.

To turn off the appliance press the first speed button again.

Check the recommended speed according to the table below.

The Hob²Hood is an automatic function which connects the hob with the hood. Both the hob and the hood have an infrared signal communicator. The speed of the fan is defined automatically on the basis of the mode setting and the temperature of the hottest cookware on the hob. You can also operate the fan using the hob manually. The function can be activated from the panel of the hob.

The filter alarm reminds you to change or clean the charcoal filter and the grease filter.

• The filter indicator is turned on for 30 seconds if the grease filter must be cleaned.

• The filter indicator flashes for 30 seconds if the charcoal filter must be replaced or cleaned.

To reset the function, press the filter notification button for 3 seconds.

To activate function:

1. Press the filter notification button for 3 seconds. If the function is activated, the indicator flashes two times.

To deactivate function:

1. Press the filter notification button for 3 seconds. If the function is deactivated, the indicator flashes once.

The appliance can be controlled with a remote-control. The connection is originally enabled.

To connect or disconnect the remote-control:

1. Switch off the appliance.

2. Press the maximum speed button for 3 seconds.

The indicator on the control panel flashes twice if the function is enabled and once if it is disabled.

Notes on cleaning:

• Do not use abrasive detergents and brushes.

• Clean the surface of the appliance with a soft cloth with warm water and a mild detergent.

• After cooking some parts of the appliance can get hot. To avoid stains, the appliance must be cooled down and dried with a clean cloth or paper towels.

• Clean stains with a mild detergent.

Keep the hood clean:

• Clean the appliance and grease filters each month. Clean the interior and grease filters carefully from fat. Fat accumulation or other residue may cause fire.

• Grease filters can be washed in a dishwasher. The dishwasher must be set to a low temperature and a short cycle. The grease filter may discolour, but this has no influence on the performance of the appliance.

Charcoal filter:

• The time of saturation of the charcoal filter varies depending on the type of cooking and the regularity of cleaning the grease filter. The activated charcoal filter is not washable, cannot be regenerated and must be replaced approximately every 4/6 months of operation, or more frequently for particularly heavy usage.

Filters are mounted with the use of clips and pins on the opposite side.

To clean the filter:

1. Press the handle of the mounting clip on the filter panel underneath the hood (1).

2. Slightly tilt the front of the filter downwards (2), then pull. Repeat the first two steps for all filters.

3. Clean the filters using a sponge with non-abrasive detergents or in a dishwasher. The dishwasher must be set to a low temperature and a short cycle. The grease filter may discolour, but it has no influence on the performance of the appliance.

4. To mount the filters back, follow the first two steps in reverse order. Repeat the steps for all filters if applicable.

WARNING! The charcoal filter is non-washable!

To replace the filter:

1. Remove the grease filters from the appliance.

2. Press the front edge in the slot towards the bottom part of the filter. Slightly tilt the front of the filter downwards.

3. To install a new filter, perform the same steps in reverse order.

In any case, it is necessary to replace the filters at least every four months.

If you cannot activate the appliance, check the following possible causes:

• The appliance is not connected to a power supply or it is connected incorrectly. Check if the appliance is correctly connected to the electrical supply.

• The fuse is blown. Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician.

If the lamp does not operate, it may be defective. This appliance is supplied with a LED lamp and separate control gear (LED driver). These parts can be replaced by a technician only.

If the appliance does not absorb enough vapours, the motor speed may not be adequate for the appearing vapours. Change the speed of the motor.

If the filter alarm indicator is on, it means the filter alarm is on. The grease filter must be cleaned or the charcoal filter must be replaced or cleaned. Refer to the filter notification in the “Daily use” chapter.