JIM DUNLOP UNI-VIBE UV-1 (01) PDF MANUAL

The UV-1FC is the remote speed controller specifically designed for the Dunlop UV-1 Uni-Vibe® effect pedal.

Using a standard 1/4″ stereo cable, plug one end of the cable into the remote jack located on the UV-1 unit and the other end into the UV-1FC.

By connecting the UV-1FC foot controller, the speed and on/off functions on the UV-1 are disabled and have been transferred to the UV-1FC remote.

With the UV-1FC in the heel down position, the UV-1 is turned off.

Move the toe down slightly to activate the UV-1 effect.

To turn off the UV-1 effect, move the rocker all the way down to the heel down position.

The speed can be increased by rocking the pedal forward to the toe down position; this corresponds to a speed of approximately 8 Hz (Fast).

To decrease the speed, move the rocker towards the heel down position; this corresponds to a speed of approximately .6 Hz (Slow) before the effect turns off.

If the pedal is too loose or too tight when rocking it, you can adjust the tension. The tension adjustment is located at the rear of the pedal.

A 7/64 allen wrench is required for this adjustment.

Simply turn the allen screw counter-clockwise to loosen the pedal; clockwise to tighten.

Yes, be careful not to remove the allen screw from the pedal when adjusting the tension.