WE-VIBE DITTO (01) PDF Document

To turn on your WE-VIBE DITTO, press the control button. To turn off the device, press and hold the control button for 2 seconds.

Once the device is turned on, press the control button again to change the vibration mode. Continued pressing of the control button will cycle through the available vibration patterns.

Charge the WE-VIBE DITTO for 90 minutes. Connect the USB charging cable to the charging contacts on the device. A full charge may take up to 2 hours depending on the remaining charge.

Note that when a computer USB port is used, the device will not charge if your computer goes into sleep mode. Any USB power adapter can be used for charging.

The indicator light on the WE-VIBE DITTO communicates the following statuses:

Slow blink: Low battery

Light fast blink: Charging

Light on: Fully charged

Light off: No power or the charging cable is not properly placed

Wash the WE-VIBE DITTO with We-Vibe Clean or soap and water. Do not clean with products that contain alcohol, petrol, or acetone. Do not boil, bake, microwave, or put the device in a dishwasher.

Apply We-Vibe Lube or other water-based lubricant to the internal stimulator and your anus. Slowly insert the WE-VIBE DITTO, giving the anal muscles time to relax and stretch without pain. The external base should sit comfortably outside of the body.

Do not attempt to insert the device completely into the anus. Should this occur, seek medical attention immediately.

The WE-VIBE DITTO features the following vibration modes:

Low

Medium

High

Ultra

Pulse

Wave

Tease

Ramp

Tempo

Massage

Download the We-Connect app on your smartphone. Open the app and follow the on-screen pairing instructions. To prepare your WE-VIBE DITTO to be paired, hold down the control button for 5 seconds until the device pulses twice.

Hold down the control button on your WE-VIBE DITTO for 5 seconds until it pulses twice. Then, hold down any button on the remote for 5 seconds. Your device will pulse when it is paired with the remote. The remote operates within 3 meters (10 feet) of the device.

No. Do not use silicone lubricants because they will damage the product. Use water-based lubricant only.

No, the remote is only water-resistant. Do not submerge the remote in water. If water gets inside, open it, remove the battery, and drain away any water. After it dries out, replace the battery, close the case, and start using it again.

To replace the battery, remove the back panel to remove the battery from the remote control. Replace the old battery with a button cell, model CR2032. Put the back panel of the remote back on. Do not charge the remote control’s non-rechargeable batteries.

The WE-VIBE DITTO can only be paired with one controller at a time. If you pair your device with your smartphone, you must re-pair it to use the remote control again.

The WE-VIBE DITTO will not charge if it is too hot (+45 degrees Celsius). Once the temperature of the device reaches a safe level charging will begin automatically.

To avoid bacteria transfer do not swap the WE-VIBE DITTO from the anus to the vagina without cleaning the toy with soap and water or We-Vibe Clean made by pjur first.

Do not use desensitizing sprays or creams prior to insertion as this will prohibit your pain sensors from responding.

Do not use the device if you have decreased sensation of pain in the area of the anus since this could influence your ability to detect possible injury.

Discontinue use if you experience discomfort such as irritation, swelling, bleeding, pain, or loss of sensation.

Do not use on swollen or inflamed areas of skin.