INNOKIN KLYPSE (01) PDF Document

The INNOKIN KLYPSE consists of the following components:

1. Protective Cap

2. Pod

3. Fill Port

4. Mod

5. Airflow Inlet

6. Battery Level LED Indicator

7. USB-C Charging Port

To fill the INNOKIN KLYPSE pod, follow these steps:

1. Pull the tab on the pod to open the fill port.

2. Add your E-Liquid carefully into the port.

3. Push the tab back in to securely close the pod.

4. Important: After filling a new pod with e-liquid, you must wait at least 5 minutes before vaping to allow for proper saturation.

5. Once ready, insert the pod into the Klypse mod.

To ensure the best performance of your INNOKIN KLYPSE, follow these operational requirements:

Ensure that the battery contacts and the pod are kept clear of any debris or e-liquid residue.

Keep the pod at least 1/3 full at all times to ensure the best longevity and flavor production.

Do not attempt to vape if the pod is empty.

If you experience a burnt taste while using the device, replace the pod immediately.

Replace the pod when you notice a reduction in flavor or vapour production.

Follow these instructions for charging and safety regarding the INNOKIN KLYPSE:

Gently and correctly insert a TYPE-C USB cable into the charging port.

Only charge the device using a certified 5V wall charger and the included TYPE-C USB cable.

Never leave the device unattended while it is charging.

Do not store the device if the battery is completely depleted.

If the device is not in use, keep the battery at least 1/2 charged.

Do not store the device in direct sunlight or in environments that are excessively hot.

The INNOKIN KLYPSE uses a white LED light to communicate battery and charging status:

Battery level is greater than 10%: The LED shows a solid white light.

Battery level is less than 10%: The white light will flash 10 times.

While the device is charging: A white light will remain on.

When the device is fully charged: The light will turn off.

The technical specifications for the INNOKIN KLYPSE are as follows: