HONOR FRI-NX9 (01) PDF Document

To power on your HONOR FRI-NX9, press and hold the power button until the screen turns on.

To power off your HONOR FRI-NX9, press and hold the power button, and then touch the power off icon on the screen.

To restart your HONOR FRI-NX9, press and hold the power button, and then touch the restart icon on the screen.

If the device is unresponsive, you can force restart the HONOR FRI-NX9 by pressing and holding both the Power and Volume down buttons for more than 10 seconds.

The physical components of the HONOR FRI-NX9 are listed in the table below:

When using the NFC function on the HONOR FRI-NX9, please keep the NFC area close to other devices or objects.

For audio, use a standard Type-C digital headset with the HONOR FRI-NX9. Please note that Type-C analog headsets are not supported.

The following phenomena are normal for the HONOR FRI-NX9 and do not indicate a defect:

There may be creases on the folding area of the inner screen.

There may be sound when you fold and unfold the HONOR FRI-NX9.

The unfolded angle of the HONOR FRI-NX9 may be slightly different during normal use.

To set up your HONOR FRI-NX9, follow these instructions using the included eject pin:

Be careful not to scratch the HONOR FRI-NX9 or hurt yourself when using the eject pin. Store the pin out of reach of children.

Ensure that the card is correctly aligned and its notch is first inserted into the card tray.

The HONOR FRI-NX9 supports two nano-SIM cards, designated as nano-SIM 1 and nano-SIM 2 in the card tray.

Do not use cut or modified SIM cards with the HONOR FRI-NX9 as they might not be recognized and could damage the card tray slot.

On the HONOR FRI-NX9, you can select the default mobile data card and calling card as needed in the settings.

5G and 4G service on the HONOR FRI-NX9 depends on the support of your network carrier and their deployment of relevant services.

Service may be unavailable in certain areas due to network interference affecting the HONOR FRI-NX9.

To ensure the safety of your HONOR FRI-NX9, follow these battery and charging precautions:

Using an unapproved or incompatible power adapter, charger, or battery may damage the HONOR FRI-NX9, shorten its lifespan, or cause a fire or explosion.

When charging the HONOR FRI-NX9, ensure the power adapter is plugged into a socket near the device that is easily accessible.

Unplug the charger from the electrical outlet and the HONOR FRI-NX9 when not in use.

The HONOR FRI-NX9 contains a built-in battery. Do not attempt to replace the battery yourself, as it may damage the battery or cause the device to malfunction. You are advised to contact an authorized service center for replacement.

Keep the battery away from fire. Do not disassemble, modify, throw, or squeeze it. Do not submerge it in water or expose it to external force, as this may cause the battery to leak, overheat, or explode.

Ideal operating temperatures for the HONOR FRI-NX9 are 0 degrees Celsius to 35 degrees Celsius.

Ideal storage temperatures for the HONOR FRI-NX9 are -20 degrees Celsius to +45 degrees Celsius.

Keep the HONOR FRI-NX9 and its battery away from excessive heat and direct sunlight. Do not place them on or in heating devices like microwave ovens, stoves, or radiators.

To prevent possible hearing damage, do not listen at high volume levels for long periods while using the HONOR FRI-NX9.

Pacemaker manufacturers recommend maintaining a minimum distance of 15 cm between the HONOR FRI-NX9 and a pacemaker to prevent potential interference.

If you use a pacemaker, hold the HONOR FRI-NX9 on the side opposite the pacemaker and do not carry the device in your front pocket.

Observe local laws and regulations while using the HONOR FRI-NX9. To reduce the risk of accidents, do not use your wireless device while driving.

While flying in an aircraft or immediately before boarding, only use the HONOR FRI-NX9 according to the instructions provided. Use of wireless devices in an aircraft may disrupt wireless networks, present a hazard to operation, or be illegal.

To avoid damaging the internal circuits of the HONOR FRI-NX9 or its charger, do not use the device in dusty, damp, or dirty places, or near a magnetic field.

Do not use, store, or transport the HONOR FRI-NX9 where flammables or explosives are stored, such as gas stations, oil depots, or chemical plants.

Dispose of the HONOR FRI-NX9, its battery, and accessories according to local regulations. They should not be disposed of in normal household waste.

The symbol on the HONOR FRI-NX9, battery, or packaging indicates that these products should be taken to separate waste collection points designated by local authorities at the end of their lifespan to ensure EEE waste is recycled properly.

The HONOR FRI-NX9 complies with RF specifications when used near your ear or at a distance of 0.50 cm from your body.

For countries that adopted the SAR limit of 2.0 W/kg over 10 grams of tissue, the highest reported SAR values for the HONOR FRI-NX9 are:

Head SAR: 0.78 W/kg

Body SAR: 1.12 W/kg

Exposure can be reduced by using a hands-free kit to keep the HONOR FRI-NX9 away from the head and body. Ensure device accessories, such as a case or holster, do not contain metal components.