EVEN CHILL BCD-455WTE-A1-04H (01) PDF Document

For the EVEN CHILL BCD-455WTE-A1-04H, the wire of the unit and the outer wire must meet the following requirements for proper connection and normal use. Please note that this DC unit is not equipped with a power source; you must purchase one from an authorized dealer.

To connect the power wires to your EVEN CHILL BCD-455WTE-A1-04H, follow these steps:

1. Connect the terminal marked with a ① to the Positive pole of the 12V DC power source.

2. Connect the terminal marked with a ② to the Negative pole of the 12V DC power source.

3. If the unit is installed in an RV, the GND terminal (marked with ③) should be connected to a metal portion of the RV.

It is recommended that only authorized or qualified professionals perform repair services on the unit. The operation of the refrigerator is dependent on a good, clean ground connection.

The main parts of the EVEN CHILL BCD-455WTE-A1-04H refrigerator are:

1. Shelf bar

2. Glass shelf

3. Crisper

4. Freezer upper drawer

5. Freezer lower drawer

To avoid the possibility of child entrapment with your EVEN CHILL BCD-455WTE-A1-04H, please take the following precautions before you dispose of your refrigerator:

• Remove all doors.

• Leave shelves in place so children may not easily climb in.

• Never allow children to play with, operate, or crawl inside the refrigerator.

Additionally, children should be supervised to ensure that they do not play with the appliance.

Before using your EVEN CHILL BCD-455WTE-A1-04H refrigerator:

1. Remove all exterior and interior packing materials.

2. Before connecting the refrigerator to the power source, let it stand upright for approximately 4 hours. This will reduce the possibility of a malfunction in the cooling system from improper handling during transportation.

3. Clean the interior surface with lukewarm water using a soft cloth.

To properly install your EVEN CHILL BCD-455WTE-A1-04H:

Location:

• The appliance is designed to be free-standing only and is not designed for recessed installation.

• Install the refrigerator in a convenient location away from extreme heat and cold.

• Select a space with a strong, level floor.

• Avoid installation on weak surfaces unable to support the refrigerator when fully loaded, or in direct sunlight and near sources of heat (stove, heater, radiator, etc.), as this will hinder the performance of the appliance.

Clearance:

• Allow 1 inch of clearance space between the back and sides of the refrigerator for proper air ventilation.

• The door should protrude at least 1 inch beyond the surrounding cabinets.

• The minimum cavity dimensions for installation are: 29.1″ wide, 70.7″ high, and 30.3″ deep.

Final Step:

• Adjust the leveling feet to keep the refrigerator level.

The EVEN CHILL BCD-455WTE-A1-04H should be properly grounded for your safety. It requires a standard 9-17V, electricity ≥15A. Direct connection with an AC power source is forbidden. Do not connect this unit to an AC power source. To prevent accidental injury, the electrical cord should be secured behind the refrigerator and not be left exposed or dangling.

The control panel on your EVEN CHILL BCD-455WTE-A1-04H has three buttons:

• “Fridge” button: Press this button to adjust the setting temperature of the refrigerating room.

• “Freezer” button: Press this button to adjust the setting temperature of the freezing room.

• “ON/OFF” button: Press and hold this button for 3 seconds to enter shutdown or power-on state.

When the refrigerator door is open, the LED display turns bright. Push the “Fridge” button. The buzzer will ring, and the refrigerating room will enter the setting condition. The temperature pattern will flash, and each press increases the temperature setting. The temperature will cycle as “01”-“02”-“03”-“04”-“05”-“06”-“07”-“–”-“01”.

When the temperature display shows “07”, pressing the “Fridge” button again will turn the refrigerator to the condition of pre-closing the refrigerating room, and the LED display will show “—” with a flashing light.

When the refrigerator door is open, the LED display turns bright. Push the “Freezer” button. The buzzer will ring, and the freezing room will enter the setting condition. The temperature display will flash, and each press increases the temperature. It will recycle from “-15” to “-19”.

Warning: The temperature will be set successfully and the flash will disappear if you stop making adjustments for over 5 seconds.

To turn the refrigerator off, press and hold the ON/OFF key for 3 seconds while it is in the power-on state. All loads will turn off, the display panel will show “–” in the refrigeration and freezing temperature display areas, and the power indicator will be displayed normally.

To turn the refrigerator on, press the ON/OFF key for 3 seconds while it is in the power-off state. The refrigerator will begin operating normally.

The power indicator on the display panel indicates the input voltage level:

• When the input voltage is greater than 12.5V, the “Full” icon light is on.

• When the input voltage is less than 12.5V and greater than 11.5V, the “Mid” icon light is on.

When the door of the refrigerating room opens, the LED light turns on. If the lighting is damaged, first remove the lampshade and then replace the LED lighting. Follow these steps:

1. Please move the lampshade and the thermostat out 3-5mm in the direction of the arrow.

2. Take out the lamp shade and thermostat downwards in the direction of the arrow.

3. Pull the connection terminal, use a screwdriver to remove the LED light board, and replace it.

Note: If the LED lamp is abnormal, it should be replaced by professionals. Do not attempt to dismantle and replace it privately in order to avoid damage.

• Clean the interior and parts with a cloth soaked in lukewarm water and baking soda solution. A solution of 2 tablespoons of baking soda to a quart of water will clean and neutralize odors. Rinse and wipe dry.

• Be sure to keep the door gasket (seal) clean to keep the unit running efficiently.

• The outside of the refrigerator should be cleaned with a warm damp cloth and mild detergent. Do not use harsh or abrasive cleaners.

• Never clean refrigerator parts with flammable fluids. The fumes can create a fire hazard.

For long vacations, follow these steps for your EVEN CHILL BCD-455WTE-A1-04H:

• Remove all food.

• Clean the interior.

• Leave the doors open to avoid possible odor or mold formation.

• Use extreme caution in the case of children. The unit should not be accessible to a child’s play.

To move your EVEN CHILL BCD-455WTE-A1-04H:

• Disconnect the power source.

• Remove all the food and securely tape down all loose items such as shelves, drawers, and doors.

• Be sure the refrigerator stays in the upright position during transportation.

• The refrigerator should be located in the coolest area of the room, away from heat-producing appliances or heating ducts, and out of direct sunlight.

• Let hot foods cool to room temperature before placing them in the refrigerator.

• Be sure to wrap foods properly, and wipe containers dry before placing them in the refrigerator. This cuts down on frost build-up inside the refrigerator.

• Organize and label food to reduce door openings and extended searches.

If your EVEN CHILL BCD-455WTE-A1-04H refrigerator does not operate, check the following possible causes:

• The refrigerator is unplugged.

• The circuit breaker is tripped or the fuse is blown.

The compressor may turn on and off frequently for several reasons:

• The room temperature is warmer than normal.

• The door is left open or is frequently opened.

• The refrigerator does not have the correct clearances.

• The refrigerator has recently been disconnected for a period of time.

If your refrigerator compartments are too warm, consider these possible causes:

• The temperature control is not set correctly.

• The door is left open or is frequently opened.

• The door gasket does not seal properly.

• A large amount of warm or hot food was stored recently. Wait for the refrigerator to reach its selected temperature.

• The refrigerator has recently been disconnected for a period of time.

Slight vibration is normal. If your EVEN CHILL BCD-455WTE-A1-04H is vibrating or rattling excessively, check the following:

• The leveling legs need adjusting.

• The refrigerator is placed on an uneven or weak surface.

• The refrigerator is touching the wall. Re-level the refrigerator and move it away from the wall.

The exterior refrigerator walls can be as much as 30°F warmer than the room temperature. This is normal while the compressor works to transfer heat from inside the refrigerator cabinet.

If moisture is collecting inside the refrigerator, it is likely because the door is left open or is frequently opened.

This is normal in hot and humid weather. Air carries moisture into the refrigerator when doors are opened.

• Bubbling or gurgling sounds (like boiling water) are the normal sound of refrigerant (used to cool the refrigerator) circulating throughout the system.

• Popping or cracking sounds when the compressor comes on are also normal. Metal parts undergo expansion and contraction, like hot water pipes. The sound will level off or disappear as the refrigerator runs.

If the door will not close properly, check for the following issues:

• The refrigerator is not on a level surface.

• The gasket is dirty.

• The storage basket is out of position.