BLUE STAR SUPER COOLER SC650F-B (01) PDF Document

Please follow these safety instructions when using your BLUE STAR SUPER COOLER SC650F-B:

1. Do not modify the power cord length or share the outlet with other appliances. Do not replace the power cord with a damaged or unspecified cord. If the power cord is damaged, it should be replaced by an authorized service person.

2. Plug into the power socket properly. A loose plug can cause electric shock or fire due to heat generation.

3. Do not switch the Super Cooler ON/OFF with wet hands, as it may cause an electric shock.

4. Use only a dedicated power socket. Do not use an extension cord; otherwise, it may cause overloading and intermittent tripping of other appliances or household lights.

5. Never splash water on your Super Cooler, as it may cause a short circuit.

6. In the event of an electric short circuit, grounding (earthing) is essential. This appliance must be grounded. Improper use of the grounding plug can result in an electric shock.

7. Never unplug your Super Cooler by pulling on the power cord. Always grip the plug firmly and pull it straight out from the outlet.

8. When moving the appliance, be careful not to roll over or damage the power cord.

9. Unplug the power cord before cleaning or for other requirements. Never touch it with wet hands.

10. Do not damage, process, pull out, or twist the power cord.

11. Do not place a lit candle inside the Super Cooler to deodorize. It may cause an explosion or fire.

12. Do not use or store inflammable materials like ether, benzene, alcohol, medicine, LP gas, spray, or cosmetics near or in the Super Cooler.

13. If you detect any strange smell or smoke, disconnect the power plug immediately and contact the service center.

14. The Super Cooler should be positioned so that the supply plug is accessible for quick disconnection in case of an accident.

The range of operating voltage is 187-242V. To avoid damaging the electrical performance of the compressor, please equip it with a voltage stabilizer of power not less than 500W to protect the cooler when the voltage is lower than 187V or higher than 242V.

An individual single-phase socket must be used. It should be reliably connected to a grounding wire. The grounding wire should not be connected to a water pipe or a gas pipe.

Yes, strong base, strong acid, organic solvent, and corrosive goods or those that easily pollute food are prohibited from being stored in the showcase; otherwise, it can cause corrosion or an accident.

1. Before use, the Super Cooler must be properly installed and located as per the installation instructions.

2. After your Super Cooler is in operation, do not touch the cold surface in the compartment, particularly when your hands are damp or wet. Skin could adhere to these extremely cold surfaces.

3. Wait for 10 minutes or longer when reconnecting the plug. This may cause the operation of the Super Cooler to fail.

4. Unpack all packages before using the showcase. Do not bend it over more than 60° while moving it.

5. During the initial operation, the cooler should run empty for about one hour before storing food in it.

The features of the BLUE STAR SUPER COOLER SC650F-B include:

• UV-protected galvanised sheets for interior and exterior

• Adjustable plastic-coated wire mesh shelves

• Energy-efficient cooling unit

• Eco-friendly refrigerant (R134a)

• Uniform cooling

• Clear product visibility with dual glass

• Self-closing door

• High-density PUF insulation

Follow these installation instructions for your BLUE STAR SUPER COOLER SC650F-B. Failure to comply may result in high energy consumption, poor performance, and void warranty.

1. After unpacking, check the cabinet for any damage caused during transportation.

2. Always ensure that your merchandiser is installed on a stable surface/floor and is properly leveled. There are 2 adjustable feet at the front, under the chassis. Please adjust until the unit levels and check using a spirit level, if available. Improper leveling might result in cabin deformation affecting performance.

3. The Super Cooler must stand upright for at least 1 hour after transportation and prior to start-up. This gives the oil time to run back to the compressor. If the cabinet has been excessively tilted, allow 3 hours before operation.

4. Allow a minimum gap of 100mm at the top, approx 100mm at the rear (use the rear spacer supplied with the unit), and 50mm at the sides of the cooler for proper ventilation. Do not place anything on top of the unit.

Do not place the cooler in the following locations:

• In direct sunlight or near heat sources (radiators, stoves & other heating equipment).

• Outdoors, without proper protection from rain, moisture, and other atmospheric elements.

• In weather conditions for which it is not certified.

• In extreme environmental conditions (i.e., extensive exposure to saline humidity, areas with potential water accumulation).

• On a surface angled by more than 5°.

• Under a roof-mounted ventilation system and near to air streams.

• Do not install in a wet place or a place where water or rain splashes, as this may cause deterioration of insulation and lead to electric leakage.

• The showcase should be installed in a cool, dry environment without corrosive gas, away from heat sources or direct sunlight. Allow more than 10cm of space between the wall and the back of the showcase.

Connect the unit to a power supply on a minimum 10A fused and grounded socket. If the mains cord supplied is not long enough, do not use an extension lead; ask an authorized electrician to replace the cord with a longer one.

Do not connect the merchandiser to:

• A non-grounded wall socket or power line.

• Improper supply voltage and frequency.

• Power supply that does not comply with the safety regulations of the appliance or with current legislation on electrical installations.

Do not plug the cooler into a multiple outlet strip or use extension cables. Route the power cables so they are protected from damage and do not pose a tripping risk.

To adjust a shelf, first unload it. Then, lift it and unclip the 4 shelf clips. Place the clips in the desired position and reposition the shelf. Make sure that the horizontal metal rods at the bottom of the shelf are between the front and back shelf clips. Never reposition a shelf when it is loaded with products.

To minimize power consumption and improve performance, do the following:

• Since cooling consumes less power when the ambient temperature is lower, load the Super Cooler at night for ready use of chilled drinks in the morning.

• Store your back-up stock in a cool and/or dark place so that when reloaded, the unit will need much less time to cool them down.

• Wipe moisture off products before placing them inside the cooler.

• Avoid opening the door frequently or leaving it open for long.

• After one year, the fluorescent tubes emit 30% less light. Call a service technician to replace them if you wish to have stronger lighting.

Before proceeding with any cleaning or maintenance, unplug the cooler.

• It is important to clean the Super Cooler twice a year to avoid mould formation and odours. Periodical cleaning is suggested, generally every 30-45 days.

• The interior of the unit should be cleaned with a mildly soapy cloth (neutral soap or detergent) and the glass surface using a window-cleaning agent.

• The surface and inside of the showcase should be kept dry and clean. Long-term moisture will cause the showcase to rust slowly.

• Never use a water hose or high-pressure jet to clean the cooler.

• Do not remove safety devices (grates, guards, groundings, etc.).

• Keep the cooler in a stable position during cleaning; do not step on or lean over it.

• Do not clean with sharp objects, flammable or corrosive liquids or sprays.

• If bottles break and liquid spills, unplug the cooler before you clean the liquid. Use protective gloves to protect yourself from broken glass.

• Cleaning and user maintenance shall not be made by children without supervision.

Before calling for professional service, please check the following. Always unplug the cooler before performing any cleaning or maintenance.

If after all the above-mentioned checks the problem with your unit remains, contact the customer service department.

This product at its end of usable life should not be mixed with household domestic waste or any general waste. It must be stored separately and disposed of through an authorized recycler of electrical and electronic appliance waste since it is categorized under Schedule I of E-Waste Management Rules promulgated by the Government of India.

As guided by these rules, this product needs to be disposed of after its useful life in a scientific and prescribed manner.

DOs:

• Run and maintain the product as per instructions given in the User’s Manual.

• Engage only an authorized person to attend to repairs of your product.

• Call on the toll-free number for assistance to dispose of your product if required.

• Engage only an authorized person for dismantling.

• Consult our local authorized dealer or contact our toll-free number to know the lifespan of your product.

DON’Ts:

• Do not try to repair/dismantle your product by yourself.

• Do not engage any unauthorized person to repair/dismantle your product or any of its parts.

• Do not sell or dispose of your product or its parts to a local scrap dealer.

• Do not dispose of E-Waste in landfills or leave it outside unattended.

• Do not put the product to any other use post its end-of-life.