BLAUBERG BLABDUCTO 125 (01) PDF Document

The BLAUBERG BLABDUCTO 125 is an axial fan designed for exhaust or supply ventilation of small and medium-sized premises. It is specifically designed for connection to 125 mm air ducts.

The following safety requirements must be observed when using the BLAUBERG BLABDUCTO 125:

– All applicable local and national construction, electrical, and technical norms and standards must be followed.

– Disconnect the unit from the power supply prior to any connection, servicing, maintenance, and repair operations.

– Only qualified electricians with a work permit for electrical units up to 1000 V are allowed for installation.

– Check the unit for any visible damage to the impeller, the casing, and the grille before starting installation.

– Ensure the casing internals are free of any foreign objects that can damage the impeller blades.

– While mounting the unit, avoid compression of the casing as deformation may result in motor jam and excessive noise.

– Misuse of the unit and any unauthorized modifications are not allowed.

– Do not expose the device to adverse atmospheric agents such as rain or sun.

– Transported air must not contain any dust, solid impurities, sticky substances, or fibrous materials.

– Do not use the unit in hazardous or explosive environments containing spirits, gasoline, insecticides, etc.

– Do not close or block the intake or extract vents.

– Do not sit on the unit and do not put objects on it.

– Never touch the unit with wet or damp hands.

– Precautions must be taken to avoid the back-flow of gases into the room from open flues of gas or other fuel-burning appliances.

The delivery set includes:

– Fan – 1 pc.

– Screws and dowels – 4 pcs.

– User’s manual – 1 pc.

– Packing box – 1 pc.

The operation guidelines for the BLAUBERG BLABDUCTO 125 include:

– The fan is rated for connection to single-phase AC power mains.

– The ingress protection rating against access to hazardous parts and water ingress is IPX4 (for the mounted product).

– The fan is rated for operation at ambient temperatures ranging from +1 degree Celsius to +45 degrees Celsius. Do not operate the fan outside this specified temperature range.

– The unit is rated as a Class II device (220-240 V/50 Hz and 220 V/60 Hz).

– Connection to the mains must be made through a disconnecting device integrated into the fixed wiring system with contact separation in all poles that allows for full disconnection under overvoltage category III conditions.

The BLAUBERG BLABDUCTO 125 is designed for vertical or horizontal installation into a round air duct of a matching diameter.

– In case of vertical mounting, the fan must be protected against the ingress of rainfall and condensate inside the fan.

– Use the mounting bracket provided to install the fan.

– Do not use a metal screwdriver, knife, or similar tools for adjustment operations to avoid damaging the circuit board.

Maintenance for the BLAUBERG BLABDUCTO 125 should be performed at least once every 6 months, depending on operating conditions. Follow these steps:

– Disconnect the fan from the power mains prior to any maintenance and take measures to prevent unintentional power-up.

– Clean the surfaces of the fan to remove dust and dirt.

– Check the reliability of electrical connections.

– Warning: Do not allow water or liquid to come into contact with electric components.

Warning: If there are any unusual oscillating movements, immediately stop using the appliance and contact the manufacturer or a suitably qualified person.