BEYERDYNAMIC AVENTHO 100 LD673030 (01) PDF DOCUMENT

Before using the BEYERDYNAMIC AVENTHO 100 LD673030 headphones, please adhere to the following safety instructions:

• Please read these safety instructions carefully and completely before use.

• Please observe all instructions given, especially those concerning the safe use of the product.

• Observe the detailed operating instructions.

• Do not use the headphones if they are defective.

Only use the BEYERDYNAMIC AVENTHO 100 LD673030 headphones as described in the product manual. Beyerdynamic is not liable for:

• Damage to the product or injury to persons caused by careless, improper, or incorrect use, or for purposes not specified by the manufacturer.

• Damage to USB devices that do not comply with USB specifications.

• Damage resulting from connection interruptions due to batteries being empty or too old, or due to exceeding the Bluetooth® transmission range.

Please also observe the relevant country-specific regulations before using the headphones.

High volumes and long listening can permanently damage your hearing. Follow these guidelines for adjusting the volume:

• Before putting on the headphones, set the volume to minimum. Only increase the volume afterwards.

• When listening and speaking normally with the headphones, your voice should still be perceptible.

• In case of tinnitus, decrease the volume. If necessary, consult a doctor.

• Excessively high volumes and long listening times may cause hearing damage.

• As a rule of thumb, the higher the volume, the shorter the listening time.

Liquid penetration can damage the BEYERDYNAMIC AVENTHO 100 LD673030. To prevent this:

• Make sure that no liquids penetrate the headphones (e.g., when cleaning).

• Do not use solvent-based or aggressive cleaning agents.

Excessive heat, water, and mechanical stress may cause explosion, heat, fire, smoke, or fumes, which can lead to injuries and irreversible damage to the battery. To ensure safety:

• Do not expose the battery to excessive heat, fire, or extremely low air pressure.

• Do not subject the battery to mechanical stress (e.g., crushing).

• Do not open the housing or remove the battery.

• Only use a USB 2.0/3.0 standard-compliant 5V power supply to charge the battery via the integrated USB Type-C port.

• Once the device is fully charged, disconnect the USB connecting cable from the charging unit.

If the battery is not going to be used for an extended period, set the charge level to approximately 50% of the maximum capacity and store it at temperatures up to a maximum of 30 °C.

Do not expose the product to rain, snow, liquids, or moisture.

Dispose of batteries separately from the product after use, in accordance with applicable regulations. They must not be disposed of in household waste. Before disposal, discharge the batteries and put tape on the terminals. A non-destructive removal of the battery by the end user is not possible.

This device complies with Part 15 of the FCC Rules and with Innovation, Science and Economic Development Canada’s licence-exempt RSS standard(s). Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and

2. This device must accept any interference received, including interference that may cause undesired operation.

CAUTION: Changes or modifications made to this equipment not expressly approved by beyerdynamic may void the FCC and user authorization to operate this equipment.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, you are encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

To access the product certification marks, remove the ear pad from the housing.