ARCTIC KING AC7ETWCR1RCM (01) PDF Document

Before using your ARCTIC KING AC7ETWCR1RCM, please follow these initial setup steps:

1. Remove all exterior and interior packing materials.

2. Check to ensure you have all of the following parts: 1 Storage Basket, 1 Instruction Manual, and 1 plastic scraper.

3. Before connecting the freezer to the power source, let it stand upright for approximately 2 hours. This will reduce the possibility of a malfunction in the cooling system from handling during transportation.

4. Clean the interior surface with lukewarm water using a soft cloth.

To properly install your ARCTIC KING AC7ETWCR1RCM, follow these guidelines:

• This appliance is designed to be free-standing only and should not be recessed or built-in.

• Place your freezer on a floor that is strong enough to support the freezer when it is fully loaded.

• Allow 15 cm of space between the back and sides of the freezer, which allows for proper air circulation.

• Locate the freezer away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating, and heat sources may increase electrical consumption. Extreme cold ambient temperatures may also cause the freezer not to perform properly.

• Avoid locating the freezer in moist areas.

• Plug the freezer into an exclusive, properly installed-grounded wall outlet. Do not under any circumstances cut or remove the third (ground) prong from the power cord.

• After plugging the appliance into a wall outlet, allow the unit to cool down for 2-3 hours before placing food in the freezer compartment.

Your ARCTIC KING AC7ETWCR1RCM has one control for regulating the temperature, which is located on the lower right-hand corner.

The range of the temperature control is from position “MIN, MAX and OFF”. Adjust the temperature control to the setting that best suits your needs.

If the unit is unplugged, loses power, or is turned off, you must wait 3 to 5 minutes before restarting the unit. If you attempt to restart before this time delay, the freezer will not start.

Additionally, note that large amounts of food will lower the cooling efficiency of the appliance. If you choose to change the thermostat setting, adjust the control by one numerical increment at a time and allow several hours for the temperature to stabilize between adjustments.

For the most efficient operation and minimum energy consumption, defrost the freezer when the frost on the freezer walls is excessive or 5 to 10 mm thick. It is best to choose a time when the stock of frozen food is low.

CAUTION: Do not use boiling water because it may damage the plastic parts. In addition, never use a sharp or metallic instrument to remove frost as it may damage the cooling coils and will void the warranty. We recommend using the plastic scraper provided with your unit.

1. Remove the frozen food from the freezer and place it in a cooler to protect the food.

2. Unplug the freezer. The Power Supply light should be off (green light out).

3. During defrosting, the ice melts into the cabinet.

4. Remove the drain plug on the inside floor of the freezer by pulling straight out.

5. Place a shallow pan outside the drain outlet. The defrost water will drain out.

6. Check the pan occasionally so the water does not overflow.

7. Clean the interior of the freezer.

8. Replace the plug on the inside floor.

9. Reset the thermostat to the desired setting.

10. Allow the cabinet to cool for one hour.

11. Return food to the freezer.

HELPFUL HINT: Defrosting usually takes a few hours. Leaving the door open will help speed the process. Also, pouring warm water (not boiling) on the ice/frost will help speed melting. If you must use a scraper, please use caution – it is very easy to damage the freezer compartment and void your warranty.

• This compartment is designed for the long-term storage of frozen food. Storage time is up to three months.

• The storage life of frozen foods varies and the recommended storage time should not be exceeded. The instructions regarding the care of frozen foods should be followed when defrosting the freezer.

• Pre-packed commercially frozen food should be stored in accordance with the frozen foods manufacturer’s instructions for a three-star frozen food storage compartment or home freezer.

• Place frozen food into the freezer as quickly as possible after purchase. If there are instructions on the packet, carefully follow these instructions regarding storage times.

• The freezer door is susceptible to breaking due to excessive ice build-up. Be sure to defrost when the ice reaches 5 to 10 mm thick.

• A storage basket is provided for the organization of odd-shaped items. To reach other packages in the freezer, just slide the basket to one side, or lift it out.

Upon installation of your new appliance, it is recommended that it be cleaned thoroughly.

1. Turn the temperature control to “MIN”, unplug the freezer, remove the food and storage basket.

2. Wash the inside with a damp warm cloth containing a water and baking soda solution. The solution should be about 2 tablespoons of baking soda to a quart of water.

3. Wash the storage basket with a mild detergent solution.

4. Be sure to keep the door gasket (seal) clean to keep the unit running efficiently.

5. The outside of the freezer should be cleaned with mild detergent and warm water.

6. Dry the interior and exterior with a soft cloth.

7. The condenser coils should be vacuumed when they are dusty or dirty.

8. It is recommended that the unit be cleaned each time it is defrosted to help keep the unit odor-free and running efficiently.

Short vacations: Leave the freezer operating during vacations of less than three weeks.

Long vacations: If the appliance will not be used for several months, remove all food and unplug the power cord. Clean and dry the interior thoroughly. To prevent odor and mold growth, leave the door open slightly: blocking it open if necessary or have the door removed.

In either case, it is important to:

• Use extreme caution in the case of children. The unit should not be accessible to a child’s play.

To move your freezer safely, follow these steps:

1. Remove all the food.

2. Securely tape down all loose items inside your freezer.

3. Remove the rollers to prevent damage.

4. Tape the doors shut.

5. Be sure the freezer stays in the upright position during transportation.

• The freezer should be located in the coolest area of the room, away from heat-producing appliances or heating ducts, and out of direct sunlight.

• Let hot foods cool to room temperature before placing in the freezer. Overloading the freezer forces the compressor to run longer. Foods that freeze too slowly may lose quality or spoil.

• Be sure to wrap foods properly and wipe containers dry before placing them in the freezer. This cuts down on frost build-up inside the freezer.

• The freezer storage bin should not be lined with aluminum foil, wax paper, or paper toweling. Liners interfere with cold air circulation, making the freezer less efficient.

• Organize and label food to reduce door openings and extended searches. Remove as many items as needed at one time, and close the door as soon as possible.

If your ARCTIC KING AC7ETWCR1RCM does not operate, check the following possible causes:

• It is not plugged in.

• The circuit breaker has tripped or a fuse has blown.

There are several reasons why the compressor might cycle frequently:

• The room temperature is hotter than normal.

• A large amount of food has been added to the freezer.

• The door is open too often.

• The door is not closed completely.

• The temperature control is not set correctly.

• The door gasket does not seal properly.

• The freezer does not have the correct clearances.

• The freezer has recently been disconnected for a period of time. Four hours are required for the freezer to cool down completely.

If the internal temperature is too warm, consider these potential issues:

• The temperature control is set too warm. Turn the control to a cooler setting and allow several hours for the temperature to stabilize.

• The door is kept open too long or is opened too frequently. Warm air enters the freezer every time the door is opened. Open the door less often.

• The door is not closed completely.

• The door gasket does not seal properly.

• A large amount of warm or hot food might have been stored recently. Wait until the freezer has had a chance to reach its selected temperature.

• The freezer has recently been disconnected for a period of time. Four hours are required for the freezer to cool down completely.

If the freezer is too cold, the temperature control may be set too cold. Turn the control to a warmer setting and allow several hours for the temperature to stabilize.

These sounds are typically normal:

• Popping or cracking sound when compressor comes on: Metal parts undergo expansion and contraction, as in hot water pipes. This is normal. Sound will level off or disappear as the freezer continues to run.

• Bubbling or gurgling sound, like water boiling: Refrigerant (used to cool the freezer) is circulating throughout the system. This is normal.

If your freezer is vibrating, check the following:

• Check to assure that the freezer is level.

• The floor is uneven or weak. If the freezer rocks on the floor when it is moved slightly, be sure the floor can adequately support it. Level the freezer by putting wood or metal shims under part of the freezer.

• The freezer is touching the wall. Re-level the freezer and move it from the wall. See “Installation Instructions”.

Moisture forms on inside freezer walls:

• The weather is hot and humid, which increases the internal rate of frost build-up. This is normal.

Moisture forms on outside of freezer:

• The door is slightly open, causing cold air from inside the freezer to meet warm moist air from outside.

• The door is kept open too long or is opened too frequently. Open the door less often.

• The door is not sealed properly.

If the door is not closing properly, check for these issues:

• The freezer is not level.

• The gasket is dirty.

• The storage basket is out of position.

DANGER or WARNING:

• DANGER – Risk of Fire or Explosion. Flammable Refrigerant Used. Do Not Use Mechanical Devices To Defrost Refrigerator. Do Not Puncture Refrigerant Tubing.

• CAUTION – Risk of Fire or Explosion. Flammable Refrigerant Used. To Be Repaired Only By Trained Service Personnel. Do Not Use Mechanical Devices. Do Not Puncture Refrigerant Tubing.

• CAUTION – Risk of Fire or Explosion. Flammable Refrigerant Used. Consult Repair Manual/Owner’s Guide Before Attempting To Service This Product. All safety Precautions Must be Followed.

• CAUTION – Risk of Fire or Explosion. Dispose of Properly In Accordance With Federal Or Local Regulations. Flammable Refrigerant Used.

• CAUTION – Risk of Fire or Explosion Due To Puncture Of Refrigerant Tubing; Follow Handling Instructions Carefully. Flammable Refrigerant Used.

There is a risk of child entrapment. Before you throw away your old refrigerator or freezer:

• Take off the doors.

• Leave the shelves in place so that children may not easily climb inside.

Additionally, do not use extension cords with this appliance.

When the environment temperature and relative humidity are high, there may be frost or water dew phenomenon on the mouth box and door bar of the freezer. If this occurs, wipe it with a dry rag.