AMAZON BASICS B07V2NRP5R (01) PDF DOCUMENT

When using the product, basic safety precautions should always be followed to reduce the risk of injury, including the following:

For domestic and office use only.

A competent adult must assemble this product.

Keep children and pets away while assembling up the product.

Always use on a firm, level ground.

Do not use this product if any parts are missing, damaged or worn.

To avoid scratching the floor, assemble the product on a soft surface, such as a carpet.

Do not overtighten the fasteners (hardware).

Regularly examine the product for wear and tear. Replace at first sign of damage or if parts become detached.

Assemble the product in a spacious area, preferably on a carpet, near the place where the unit is to be located.

Do not stand on the seat. Do not sit on the armrest.

The product is intended for users up to 265 lbs (120 kg).

The gas lift must be replaced and/or repaired by a qualified professional only.

Keep all sharp objects away from the upholstery.

Check the product for transport damages.

DANGER Risk of suffocation! Keep any packaging materials away from children – these materials are a potential source of danger, e.g. suffocation.

Step 1: Assemble the Base

Insert the five casters (A) into the legs of the star base (B). Then, insert the gas lift cylinder (C) into the center hole of the base.

Step 2: Attach the Seat Plate

Align the seat plate (D) with the pre-drilled holes on the bottom of the seat cushion (G). Ensure the front of the seat plate faces the front of the seat cushion. Secure it using four 1/4″ x 7/8″ screws (H) with the Allen wrench (M).

Step 3: Attach the Backrest

Attach the backrest (F) to the mechanism on the seat plate using four 5/16″ x 1-1/4″ screws (I) with the Allen wrench (M).

Step 4: Combine Chair Top and Base

Carefully lower the assembled seat and backrest section onto the gas lift cylinder (C) that is attached to the base.

Step 5: Attach the Armrests

Attach the two armrests (E) to the sides of the seat and backrest using four 5/16″ x 1-1/2″ screws (J) and four washers (K). Tighten the screws with the Allen wrench (M).

Step 6: Install Screw Covers

Press the four screw covers (L) into the screw holes on the outside of the armrests to conceal the screws.

To raise or lower the seat height, pull up on the lever located under the right side of the seat. Release the lever once the desired height is reached.

The same lever used for height adjustment also controls the tilt lock.

To unlock the chair and allow it to tilt, pull the lever outwards.

To lock the chair in the upright position, push the lever inwards.

To adjust the tension of the chair’s tilt, use the large round knob located under the front of the seat.

Turn the knob clockwise (+) to increase the tilt tension, making it harder to recline.

Turn the knob counter-clockwise (-) to decrease the tilt tension, making it easier to recline.

To clean the product, wipe with a soft, slightly moist cloth.

Never use corrosive detergents, wire brushes, abrasive scourers, metal or sharp utensils to clean the product.

Check the components regularly to make sure all screws and bolts are tightened.

Store in a cool and dry place away from children and pets, ideally in original packaging.

Vacuum the upholstery regularly. Small dust particles are very abrasive and can wear furniture prematurely.

Avoid placing the product furniture in direct sunlight as color may fade over time when placed in direct sunlight.

Try to maintain at least 3 feet (1 meter) between the product and any heat sources. Prolonged exposure to heat sources or radiators causes cracking in the leather.