AMAZON BASICS B07995MHFL (01) PDF MANUAL

Read these instructions carefully and retain them for future use. If this product is passed to a third party, then these instructions must be included.

When using the product, basic safety precautions should always be followed to reduce the risk of injury including the following:

Do not let children climb on or play with the unit.

This product must be assembled by competent adults.

Always use on a firm level ground.

Do not sit or hang on the product.

Keep the wheels locked unless there is a need to move the product.

Check to ensure that all components and fixings of this product are secure, do not use if you have any doubts about its fitness for purpose.

To avoid scratching the floor, assemble the shelving unit on a soft surface such as a carpet.

Load the unit evenly and place the heaviest items on the lower shelves.

Check for transport damages.

A DANGER Risk of suffocation! Keep any packaging materials away from children – these materials are a potential source of danger, e.g. suffocation.

Discard the protective covers which are used to separate the shelves for shipping purposes only.

To clean, wipe with a soft, slightly moist cloth.

Never use corrosive detergents, wire brushes, abrasive scourers, metal or sharp utensils to clean the product.

Product dimensions (W x H x D):	approx. 35.8 x 14 x 72 inch (91 x 35.5 x 183 cm)
Product net weight:	approx. 24.27 lbs (11.02 kg)
Loading capacity when moving:
– whole unit	200 lbs (90.7 kg)
– top shelf	50 lbs (22.7 kg)
– bottom shelf	50 lbs (22.7 kg)
– each hanging rod	50 lbs (22.7 kg)
Loading capacity when not moving:
– whole unit	400 lbs (181.4 kg)
– top shelf	100 lbs (45.4 kg)
– bottom shelf	100 lbs (45.4 kg)
– each hanging rod	100 lbs (45.4 kg)

1. Snap pairs of plastic clips (H) onto the grooves of the lower poles (C) at the desired height for the bottom shelf. Ensure the “TOP” arrow on the clips points upwards. Repeat for all four lower poles.

2. Screw the wheels (F – locking, G – non-locking) into the bottom of the lower poles (C). Place the bottom shelf (A) over the tops of the four lower poles and slide it down until it rests firmly on the plastic clips (H).

3. Snap pairs of plastic clips (H) onto the grooves of the lower poles (C) at the desired height for the hanging rod supports (D). Slide the supports (D) down onto the clips.

4. Screw the upper poles (B) onto the top of the lower poles (C).

5. Snap pairs of plastic clips (H) onto the grooves of the upper poles (B) at the desired height for the top shelf. Place the top shelf (A) over the tops of the four upper poles and slide it down until it rests firmly on the plastic clips (H).

6. Attach the hanging rods (E) between the supports (D) using the provided screws (I) and Allen key (J).

To ensure better stability of the product when locked, place both locking wheels (F) along the same longer edge of the product.

To lock the wheels with brakes (F), press on the ON pedal. To unlock, press on the OFF pedal.

To obtain a copy of the warranty for this product:

US: amazon.com/AmazonBasics/Warranty

UK: amazon.co.uk/basics-warranty

US: +1-866-216-1072

UK: +44 (0) 800-279-7234

To leave a review:

US: amazon.com/review/review-your-purchases#

UK: amazon.co.uk/review/review-your-purchases#

To contact customer service:

US: amazon.com/gp/help/customer/contact-us

UK: amazon.co.uk/gp/help/customer/contact-us