ALLIANCE AWN43RSN115CW14 (01) PDF Document

To enter the Factory Test Procedure, follow these steps:

1. Disconnect electrical power from the ALLIANCE AWN43RSN115CW14.

2. Reconnect electrical power to the unit.

3. Wait about 10 seconds.

4. Turn the Cycle Selection knob to the opposite of Normal Eco and stay on that selection for at least one second.

5. Press and hold the Start/Pause button.

6. Change the Cycle Selection knob to Normal Eco within 5 seconds or the Start press will be invalid.

7. Stay on Normal Eco for at least one second to enter the Factory Test Mode.

8. To advance through the sequence of test steps, press the Start/Pause button.

For the ALLIANCE AWN43RSN115CW14, follow these steps to advance to the final spin or drain:

1. Make sure EXTRA RINSE is in the OFF position.

2. Press and hold the START/PAUSE button. After about three seconds, the current cycle status light will turn off.

3. Continue holding the START/PAUSE button for another 7 to 8 seconds until the SPIN light comes on, then release the button.

4. If the lid was unlocked, the LID LOCK light will come on and the lid will lock. Once locked, the machine will start to drain and spin.

5. After the final spin or drain step, the control will reset to normal operation.

You can test the mixing valve solenoids using an Ohm meter. Please note that resistance readings slightly out of the given ranges may be due to meter conditions and do not necessarily indicate mixing valve failure.

For the ALLIANCE AWN43RSN115CW14, the resistance values are as follows:

120 Volt valves: 900 to 1100 Ohms.

240 Volt valves: 3200 to 4000 Ohms.

If the ALLIANCE AWN43RSN115CW14 displays this error code during the first fill, it could indicate the pressure sensor harness is installed incorrectly. Follow these steps to correct it:

1. Disconnect electrical power from the unit.

2. Remove the screws holding the hood assembly to the rear hood panel.

3. Tip the control panel down to locate the H7 connection block (a 4-pin block with white, red, and gray wires).

4. Press the connection block release arm and remove the block.

5. Relocate the connection block so the release arm is at the three o’clock position to match the lock tab of the block on the control.

6. Re-install the control hood.

7. Reconnect electrical power to the unit.

8. Run the washer through a cycle to verify proper operation.

Follow these steps to level the ALLIANCE AWN43RSN115CW14:

1. Place a level on the cabinet top and check if the washer is level from side to side and front to back.

2. If the washer is not level, tilt the washer back to access the front leveling legs. Loosen the locknuts and adjust the legs by screwing them into or out of the washer base.

3. Once adjusted, tilt the washer forward on the front legs and lower it back down into position to set the rear self-leveling legs.

4. The washer must not rock. When the washer is level and does not rock, tighten the locknuts securely against the bottom of the washer base. If these locknuts are not tight, the washer will not remain stationary during operation.

When replacing or reinstalling the drive bell on the ALLIANCE AWN43RSN115CW14, torque the bolts to the following specifications:

Drive Bell to Washtub and Hub: 100 to 140 inch-pounds [11.3 to 15.8 Nm].

Drive Bell to Top of Drive Shaft: 60 to 100 inch-pounds [6.78 to 11.3 Nm].